Chair of Processing of Composites and Design for Recycling (270)
Organisational unit: Chair
341 - 350 out of 372Page size: 10
Research output
- Published
ACTIVE RTM PROCESS MANAGEMENT BASED ON PHENOMENOLOGICAL MODELS
Fauster, E., Hergan, P. & Schledjewski, R., 2021.Research output: Contribution to conference › Paper › peer-review
- Published
Experimental characterization of single ply out-of-plane permeability through gaseous flow
Fauster, E., Vierkötter, C., Appel, L., Lugo, J., Schijve, W. & Heider, D., Sept 2018, In: Polymer Composites. 39.2018, 9, p. 3247-3258 12 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Investigation of the influence of speed increase in pultrusion by means of design of experiment on the barrier properties of glass fiber reinforced polyester profiles.
Ekam, M., 2023Research output: Thesis › Master's Thesis
- Published
Entwicklung eines Serienfertigungskonzepts für GFK-Schlaufen mit den Anforderungen an hohe Stückzahlen in der Bauindustrie
Dietrich, A. M., 2013Research output: Thesis › Master's Thesis
- Published
Improved cure simulation in pultrusion process about heating systems: A case study
Costa Dias, R. D. C., Santos, L. S. & Schledjewski, R., 26 Jun 2016, Proceedings of the 17th European Conference on Composite Materials (ECCM17).Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Improving degree of cure in pultrusion process by optimizing die-temperature
Costa Dias, R. D. C., Santos, L. D. S., Ouzia, H. & Schledjewski, R., 1 Dec 2018, In: Materials Today Communications. 17.2018, December, p. 362-370 9 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Comparative study of optimization in pultrusion with pre-heating and die-cooler temperature for improved cure
Costa Dias, R. D. C., de Sousa Santos, L. & Schledjewski, R., 1 Jan 2017, THERMEC 2016. Ionescu, M., Mishra, B., Kozeschnik, E., Sommitsch, C., Chandra, T. & Mishra, B. (eds.). Trans Tech Publications, p. 402-407 6 p. (Materials Science Forum; vol. 879).Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Kinetic parameter estimation and simulation of pultrusion process of an epoxy-glass fiber system
Costa Dias, R. D. C., Leali Costa, M., Santos, L. D. S. & Schledjewski, R., 22 Jun 2020, In: Thermochimica Acta. 690.2020, August, 12 p., 178636.Research output: Contribution to journal › Article › Research › peer-review
- Published
Pultrusion of thermoset based profiles-state of the art regarding materials, process set-ups, process modeling, and process simulation
Costa Dias, R. D. C., 2020Research output: Thesis › Doctoral Thesis
- Published
Evaluation of repairing techniques for damaged natural fiber reinforced composites
Cardenas Velasco, J., 2023Research output: Thesis › Master's Thesis
