Chair of Polymer Processing (350)
Organisational unit: Chair
Research output
- Published
Presentation of a Novel Sensor Based on Acoustic Emission in Injection Molding
Müller, F., Rath, G., Lucyshyn, T., Kukla, C., Burgsteiner, M. & Holzer, C., 2013, In: Journal of Applied Polymer Science. 127, p. 4744-4749Research output: Contribution to journal › Article › Research › peer-review
- Published
Wireless Melt Front Detection for Injection Moulding
Müller, F., Kukla, C., Lucyshyn, T., Burgsteiner, M. & Holzer, C., 2014, ICIT & MPT 2014 Conference Proceedings . p. 153-159Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Influence of the heat transfer coefficient on the injection molding simulation of microstructures
Müller, F., Lucyshyn, T., Kukla, C. & Holzer, C., 2011, Conference Proceedings - ICIT & MPT 2011 . p. 141-148Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Hör auf dein Werkzeug
Müller, F., Kukla, C., Lucyshyn, T. & Holzer, C., 2013, In: Kunststoffe. p. 31-33Research output: Contribution to journal › Article › Research › peer-review
- Published
Resonant Acoustic Sensor System for the Wireless Monitoring of Injection Moulding
Müller, F., O'Leary, P., Rath, G., Kukla, C., Harker, M., Lucyshyn, T. & Holzer, C., 2013, Proceedings of the 2nd International Conference on Sensor Networks. p. 153-161Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Hör auf dein Werkzeug - Schallsensorik für das Spritzgießen
Müller, F., 2013.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Performance Evaluation of Purely Mechanical Wireless In-Mould Sensor for Injection Moulding
Müller, F., Kukla, C., Lucyshyn, T. & Holzer, C., 2013, World Academy of Science Engineering and Technology. p. 55-60Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Experimentelle und numerische Untersuchungen des Einflusses von Spritzgieß-Parametern auf Bauteildimensionen unter Verwendung von zwei unterschiedlichen optischen Messsystemen
Müller, F., 2010Research output: Thesis › Master's Thesis
- Published
Analysis, Implementation and Investigation of a Wireless In-Mold Sensor for Injection Molding
Müller, F., 2014, 207 p.Research output: Thesis › Doctoral Thesis
- Published
Influence of Chain Extender on the Foaming Behavior and on the Mechanical Properteis of Physically Foamed PLA
Mostafa, H., Geißler, B., Uray, A., Laske, S., Holzer, C. & Langecker, G., 2013.Research output: Contribution to conference › Poster › Research › peer-review
