Chair of Designing Plastics and Composite Materials (250)
Organisational unit: Chair
41 - 50 out of 119Page size: 10
Research output
- 2020
- Published
Implementation of a finite element model to predict the impact behaviour of 3D-printed PMMA specimens
Moser, C., 2020Research output: Thesis › Master's Thesis
- 2019
- Published
Constitutive modeling of anisotropic plasticity with application to fiber-reinforced composites
Nagaraja, S. G., Pletz, M. & Schuecker, C., 15 Dec 2019, In: International journal of solids and structures. 180-181.2019, 15 December, p. 84-96 13 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Analysis of the critical stresses in high-voltage composite winding insulations under thermal loads
Pothukuchi, H. K. R., Fuchs, P. F. & Schuecker, C., 21 Nov 2019, In: Journal of composite materials. 54.2020, 15, p. 2073-2084 12 p.Research output: Contribution to journal › Review article › peer-review
- Published
Crack initiation in layered composites using a coupled stress-energy criterion
Shevchuk, M., 12 Nov 2019.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Verbesserter Materialeinsatz durch kombinierte Optimierung von Bauteilstruktur und Material
Lang, M. C. & Frankl, S. M., 12 Nov 2019.Research output: Contribution to conference › Poster › Research
- Published
Vorhersage des Ermüdungsverhaltens von Verbundwerkstoffen
Drvoderic, M., 12 Nov 2019. 1 p.Research output: Contribution to conference › Poster › Research
- Published
Simultaneous Structural and Material Optimisation
Lang, M. C., 16 Oct 2019.Research output: Contribution to conference › Abstract › peer-review
- Published
Cyclic plastic deformation of rails in rolling/sliding contact –quasistatic FE calculations using different plasticity models
Pletz, M., Meyer, K. A., Künstner, D., Scheriau, S. & Daves, W., 15 Oct 2019, In: Wear. 436-437.2019, 15 October, 10 p., 202992.Research output: Contribution to journal › Article › Research › peer-review
- Published
Finite Element Models Describing the Failure in Steel Cable Reinforced Rubber Composites
Frankl, S. M., 3 Sept 2019.Research output: Contribution to conference › Abstract
- E-pub ahead of print
Impact Optimization of 3D‐Printed Poly(methyl methacrylate) for Cranial Implants
Petersmann, S., Spoerk, M., Huber, P., Lang, M., Pinter, G. & Arbeiter, F., 30 Aug 2019, (E-pub ahead of print) In: Macromolecular materials and engineering. 304.2019, 11, 10 p., 1900263.Research output: Contribution to journal › Article › Research › peer-review
