Chair of Designing Plastics and Composite Materials (250)
Organisational unit: Chair
91 - 100 out of 131Page size: 10
Research output
- Published
Optimization of the specimen geometry of unidirectional reinforced composites with a fibre orientation of 90° for tensile, quasi-static and fatigue tests
Schneider, C., Drvoderic, M., Schuecker, C. & Pinter, G., 28 Jun 2019, 22nd Symposium on Composites. Hausmann, J. M. (ed.). Trans Tech Publications, p. 594-597 4 p. (Key Engineering Materials; vol. 809 KEM).Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Optimization of toughness in materials with propagating and reinitiating cracks
Rettl, M., 2024Research output: Thesis › Doctoral Thesis
- Published
Parameter Study on Force Curves of Assembled Electronic Components on Foils during Injection Overmolding Using Simulation
Hubmann, M., Bakr, M., Groten, J., Pletz, M., Vanfleteren, J., Bossuyt, F., Madadnia, B. & Stadlober, B., 19 Apr 2023, In: Micromachines. 14.2023, 4, 15 p., 876.Research output: Contribution to journal › Article › Research › peer-review
- Published
Path calculation, technology and opportunities in dry fiber winding: a review
Sofi, T., Neunkirchen, S. & Schledjewski, R., 10 Oct 2018, In: Advanced Manufacturing: Polymer and Composites Science. 4.2018, 3, p. 57-72 16 p.Research output: Contribution to journal › Review article › peer-review
- Published
Peel strength characterisation on ply/ply interface using wedge and T-peel/pull-type tests
Satheesh, B., Tonejc, M., Potakowskyj, L., Pletz, M., Fauster, E., Kaynak, B. & Schledjewski, R., 8 Nov 2018, In: Polymers & Polymer Composites (Polymers and polymer composites). 26.2018, 8-9, p. 431-435 5 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Permeability Customisation through Preform Manipulation Utilising 3D-Printing Technology
Tonejc, M., Pletz, M., Fauster, E. & Schledjewski, R., 1 Nov 2017, In: Polymers and Polymer Composites. 25.2017, 9, p. 651-660 10 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Permeability Customisation Through Preform Manipulation Utilizing 3D-Printing Technology
Tonejc, M., Pletz, M., Fauster, E. & Schledjewski, R., 1 Nov 2017, In: Polymers & Polymer Composites (Polymers and polymer composites). 25.2017, 9, p. 643-652 10 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Practical Aspects to Simultaneous Structural and Material Optimization
Lang, M. & Schuecker, C., 20 Jun 2016.Research output: Contribution to conference › Abstract › peer-review
- Published
Prediction of the failure behaviour in steel cable reinforced rubber components using the Finite Element Method
Frankl, S. M., 2022Research output: Thesis › Doctoral Thesis
- Published
Probeneinflüsse bei der mechanischen Prüfung von Composites
Drvoderic, M., 2018Research output: Thesis › Master's Thesis
