Department Polymer Engineering and Science
Organisational unit: Departments and Institutes
Research output
- 2009
- Published
- Published
Verfahrensvergleich zur Herstellung von mikro- und nanostrukturierten Oberflächen
Lemmerer, S., 2009Research output: Thesis › Master's Thesis
- Published
Viskositätsdaten für die Spritzgieß-Simulation
Duretek, I., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Viskositätsdaten für die Spritzgieß-Simulation
Friesenbichler, W., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Wear of plastic mold steels under injection molding conditions
Oláh, L. & Friesenbichler, W., 2009, In: Transactions of FAMENA. 33, p. 15-24Research output: Contribution to journal › Article › Research › peer-review
- Published
Wärmeausdehnung GFK
Pinter, G., 2009Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
Zug- und Biegeprüfung eines Polymerbeton-Verbundwerkstoffes
Pilz, G. & Lang, R., 2009Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
Zyklische Risswachstumsversuche an CRB-Proben als Qualitätssicherungstest zur Abschätzung des Langzeitverhaltens von PE-Rohrwerkstoffen
Redhead, A., 2009, 74 p.Research output: Thesis › Master's Thesis
- 2008
- Published
2. Leobener Symposium "SOLARTECHNIK - Neue Möglichkeiten für die Kunststoffbranche
Lang, R. (ed.) & Wallner, G. (ed.), 2008, Eigenverlag.Research output: Book/Report › Anthology › Research
- Published
A new practical measurement for demolding forces and coefficients of friction in injection molding
Berger, G., Friesenbichler, W., Schöfer, G. & Freudenschuß, G., 2008, Proceeding of the PPS-24. p. 1-7Research output: Chapter in Book/Report/Conference proceeding › Conference contribution