Department Polymer Engineering and Science
Organisational unit: Departments and Institutes
2881 - 2890 out of 4,042Page size: 10
Research output
- 2010
- Published
Characterization of Chlorinated Polyisoprene Surface
Lenko, D., Schloegl, S., Schaller, R., Holzner, A. & Kern, W., 2010.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Characterization of physical and chemical aging of polymeric solar materials by mechanical testing
Kahlen, S., Jerabek, M., Wallner, G. & Lang, R., 2010, In: Polymer Testing. p. 72-81Research output: Contribution to journal › Article › Research › peer-review
- Published
Characterization of the Orientation Parameters Around Crack Tips in Unfilled and Nanofilled Poly(propylene) Using in-situ Synchrotron Small and Wide Angle Scanning Scattering Techniques
Feuchter, M., Maier, G., Zizak, I., Pinter, G., Kracalik, M., Laske, S. & Langecker, G. R., 2010, MODERN TRENDS IN POLYMER SCIENCE-EPF 09. Vol. 296. p. 189-196 (MACROMOLECULAR SYMPOSIA).Research output: Chapter in Book/Report/Conference proceeding › Chapter › Research
- Published
Characterization of the Rapid Gas Decompression Behavior of HNBR Based Rubber
Schrittesser, B. C., 2010, 94 p.Research output: Thesis › Master's Thesis
- Published
Characterization of the fracture and fatigue behavior of thermoplastic elastomer materials
Major, Z., Isasi, M. & Schwarz, T., 2010, Key engineering materials. p. 789-792 (Key engineering materials).Research output: Chapter in Book/Report/Conference proceeding › Chapter › Research
- Published
Characterization of the fracture behavior of NBR and FKM grade elastomers for oilfield applications
Major, Z. & Lang, R., 2010, In: Engineering Failure Analysis. p. 701-711Research output: Contribution to journal › Article › Research › peer-review
- Published
Characterization of the global deformation behaviour of engineering plastics rolls
Berer, M. & Major, Z., 2010, In: International journal of mechanics and materials in design. p. 1-9Research output: Contribution to journal › Article › Research › peer-review
- Published
Charakterisierung des Einflusses von variierenden Prozessparametern beim Presssintern auf die Eigenschaften von ultrahochmolekularem Polyethylen (UHMWPE)
Haselwanter, D., 2010Research output: Thesis › Master's Thesis
- Published
Charakterisierung des Lichtstreuverhaltens und der Morphologie von thermotropen Verglasungen auf Thermoplastbasis
Seemann, M., 2010Research output: Thesis › Master's Thesis
- Published
Comparative ecological assessment of a sheet of paper based on the biopolymer PLA and on normal pulp
Katschnig, M., Laske, S. & Holzer, C., 2010, Book of Abstracts of ASPM 2010 Austrian-Slovenian Polymer Meeting. p. 122-122Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
