Department Polymer Engineering and Science
Organisational unit: Departments and Institutes
Research output
- 2012
- Published
Runner balancing in multi-cavity injection molds by time controlled valve gates
Lucyshyn, T., Müller, F., Doppelmayer, N., Rath, G., Kukla, C. & Holzer, C., 2012.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Selective Photo-induced Cross-linking of Polynorbornenes: Towards the Fabrication of Polymer 2D - and 3D-Mircostructures
Wolfberger, A., Grießer, T., Daschiel, U., Schmidt, V., Jerrar, A., Teichert, C. & Kern, W., 2012.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Silica nanoparticles bearing a photoreactive shell
Rieß, G., Schauberger, J., Muhr, N. & Kern, W., 2012.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Simulation des "Single Via Thermal Cycle Test" - Modellerstellung und Bestimmung der Materialeingangsparameter
Fellner, K., 2012Research output: Thesis › Master's Thesis
- Published
Simulation des Tapelegeprozesses mit thermoplastischen Matrixmaterialien
Narnhofer, M., 2012.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Simulation of materials behaviour during in-situ consolidation using continuous welding processes like thermoplastic tape placement
Schledjewski, R., Khan, M. A. & Mitschang, P., 2012, Proceedings ECCOMAS2012. p. 4298-4307Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Simulation of pipe failures
Mitev, I. & Pinter, G., 2012.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Simulation of the thermoplastic tape placement
Maurer, D., Khan, M. A., Mitschang, P. & Schledjewski, R., 2012, Proceedings 4th European Conference on Materials and Structures in Aerospace – EUCOMAS 2012. p. 1-28Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Simulations and experiments of open hole tension tests - Assessment of intra-ply plasticity, damage, and localization
Flatscher, T., Wolfahrt, M., Pinter, G. & Pettermann, H. E., 2012, In: Composites science and technology. 72, p. 1090-1095Research output: Contribution to journal › Article › Research › peer-review
- Published
Spritzgießcompoundieren
Battisti, M., 2012.Research output: Contribution to conference › Poster › Research › peer-review
