Department Polymer Engineering and Science
Organisational unit: Departments and Institutes
231 - 240 out of 4,067Page size: 10
Research output
- 2023
- Published
Photopolymere für die Additive Fertigung von Formeinsätzen für Spritzgießwerkzeuge
Sommer, K., 2023Research output: Thesis › Doctoral Thesis
- Published
Process optimization and simulation of film insert molding for electronic applications
Hubmann, M., 2023Research output: Thesis › Doctoral Thesis
- Published
Recycling of multilayer packaging film
Feuchter, M., Plevová, K., Medvid, V. & Brenn, G., 2023, 31st Leoben-Conference on Polymer Engineering and Science: Circular Thinking in Polymer Technology. p. 37-39Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Recycling of multilayer packaging film
Feuchter, M., 2023, Challenges, trends and solutions in developing and processing of recycled polymer materials.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Schallemissionsanalyse während der zyklischen Belastung von kontinuierlich faserverstärkten Kunststoffen
Gfrerrer, M., Wiener, J., Brunner, A. J. & Pinter, G., 2023, SCHALL 23: Entwicklung und Anwendung der Schallemissionsanalyse und Zustandsüberwachung mit geführten Wellen.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Screening Life Cycle Assessment comparing One-step and Two-step Injection Molding Compounding using Conservative and Optimistic Scenarios
Kirschnick, U., Shahroodi, Z., Krempl, N. & Schledjewski, R., 2023, In: WSEAS transactions on environment and development.Research output: Contribution to journal › Article › Research › peer-review
- Published
Screening Method Development for Die Drool in Extrusion Blow Moulding for PCR PEHD
Jochum, P. A., 2023Research output: Thesis › Master's Thesis
- Published
Sequentiaql orthogonality by [2+2] cycloadditions in dual-cure photopolymers
Müller, S. M., Nelson, B., Naderer, C., Sivun, D., Jacak, J., Schlögl, S. & Griesser, T., 2023.Research output: Contribution to conference › Poster › Research
- Accepted/In press
Single-Step Kinetic Predictions Based on a Constructed Isoconversional State Diagram
Tao, Q., Krivec, T. & Kern, W., 2023, (Accepted/In press) In: Macromolecular Theory and Simulations. 2024, ??? Stand: 15. Februar, p. ??? 12 p., 2300066.Research output: Contribution to journal › Article › Research › peer-review
- Published
Surface modification of inorganic fillers and their use in advanced thermoplastic polyurethane composites
Lenger, A., 2023Research output: Thesis › Master's Thesis
