Department Polymer Engineering and Science
Organisational unit: Departments and Institutes
1661 - 1670 out of 4,041Page size: 10
Research output
- 2016
- Published
Thermosets from Renewable Resources - Fundamentals, Preparation, and Properties
Mahendran, A. R. & Aust, N., 2016, Advances in Polymer Materials and Technology. Srinivasan, A. & Bandyopadhyay, S. (eds.). p. 553-571Research output: Chapter in Book/Report/Conference proceeding › Chapter › Research
- Published
Thiol-Yne Derived Photopolymers from Low-Cytotoxic 3D-Printing Resins
Hartmann, D., Oesterreicher, A., Edler, M., Moser, A., Pinter, G. & Grießer, T., 2016.Research output: Contribution to conference › Presentation › Research › peer-review
- Published
Thiol-yne Derived Resins for 3D Printing of Biocompatible Structures
Oesterreicher, A., 2016Research output: Thesis › Doctoral Thesis
- Published
Thiol‐Ene versus Binary Thiol–Acrylate Chemistry: Material Properties and Network Characteristics of Photopolymers
Sahin, M., Ayalur Karunakaran, S., Manhart, J. C., Wolfahrt, M., Kern, W. & Schlögl, S., 2016, In: Advanced engineering materials. 2016, 19, 19.Research output: Contribution to journal › Article › Research › peer-review
- Published
Tough and degradable photopolymers derived from alkyne monomers for 3D printing of biomedical materials
Oesterreicher, A., Wiener, J., Roth, M., Moser, A., Gmeiner, R., Edler, M., Pinter, G. & Grießer, T., 2016, In: Polymer Chemistry. 7, p. 5169-5180Research output: Contribution to journal › Article › Research › peer-review
- Published
- Published
Untersuchung der mechanischen Rezyklierbarkeit von technischen Biokunststoffen
Blees, E. C., 2016Research output: Thesis › Master's Thesis
- Published
Untersuchung des Temperatur- und Strömungsverhaltens beim Kautschukspritzgießen mithilfe eines neu entwickelten Schneckenprüfstands
Graninger, G., 2016Research output: Thesis › Master's Thesis
- Published
Untersuchung und Optimierung der Barriereeigenschaften von Polyolefinen gegen die Permeation von kurzkettigen Kohlenwasserstoffen
Berger, K., 2016Research output: Thesis › Doctoral Thesis
- Published
Vacuum infusion composite manufacturing using integrated carbon nanotubes sensor
Lloret Pertegas, S., Matyas, J., Slobodian, P. & Schledjewski, R., 2016.Research output: Contribution to conference › Paper
