Chair of Polymer Processing (350)
Organisational unit: Chair
51 - 60 out of 946Page size: 10
Research output
- Published
Verfahrensentwicklung von physikalisch geschäumten Polypropylenplatten für den Einsatz als Kernmaterial von Sandwichverbunden
Braun, A. C., 2011, 303 p.Research output: Thesis › Doctoral Thesis
- Published
Suitability of Recycled PLA Filament Application in Fused Filament Fabrication Process
Breški, T., Hentschel, L., Godec, D. & Duretek, I., 2021, In: Technical journal : scientific professional journal of University North . 15.2021, 4, p. 491-497 7 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Measurement of interdiffusion in polymeric materials by applying Raman spectroscopy
Bruckmoser, K., Resch, K., Kisslinger, T. & Lucyshyn, T., Sept 2015, In: Polymer Testing. 46, p. 122-133 12 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
- Published
Influencing Parameters on the Master Casting Process used for the Replication of Microstructures on Curved Surfaces via Injection Molding
Burgsteiner, M., 2013, Books of Abstracts of the 12th International Conference on NNT 2013. p. 184-184Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Replication of a draw-polished cavity surface into PP and PC. Influence of flow length, wall thickness and injection molding parameters
Burgsteiner, M., Berger, G. & Friesenbichler, W., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Investigation of the Influence of Different Coatings on the Filling Behavior and Replication Quality of Microstructures in Injection Molding
Burgsteiner, M., Müller, F., Lucyshyn, T., Kukla, C., Holzer, C., Gruber, D. P., Macher, J. & Pacher, G., 2014, Proceedings of PPS 30. p. 1-1Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Influencing Parameters on the Master Casting Process used for the Replication of Microstructures on Curved Surfaces via Injection Molding
Burgsteiner, M., 2013.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Replication of a draw-polished cavity surface into PP and PC. Influence of flow length, wall thickness and injection molding parameters
Burgsteiner, M., Berger, G. & Friesenbichler, W., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Influence of the process parameters on the replication of microstructured freeform surfaces
Burgsteiner, M., Müller, F., Lucyshyn, T., Kukla, C. & Holzer, C., 2014, AIP Conference Proceedings: PROCEEDINGS OF PPS-29: The 29th International Conference of the Polymer Processing Society - Conference Papers. Nuremberg, Germany, Vol. 1593. p. 183-188Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
