Chair of Materials Science and Testing of Polymers (210)
Organisational unit: Chair
991 - 1000 out of 1,602Page size: 10
Research output
- 2010
- Published
Characterization of the Orientation Parameters Around Crack Tips in Unfilled and Nanofilled Poly(propylene) Using in-situ Synchrotron Small and Wide Angle Scanning Scattering Techniques
Feuchter, M., Maier, G., Zizak, I., Pinter, G., Kracalik, M., Laske, S. & Langecker, G. R., 2010, MODERN TRENDS IN POLYMER SCIENCE-EPF 09. Vol. 296. p. 189-196 (MACROMOLECULAR SYMPOSIA).Research output: Chapter in Book/Report/Conference proceeding › Chapter › Research
- Published
Characterization of the Rapid Gas Decompression Behavior of HNBR Based Rubber
Schrittesser, B. C., 2010, 94 p.Research output: Thesis › Master's Thesis
- Published
Characterization of the fracture and fatigue behavior of thermoplastic elastomer materials
Major, Z., Isasi, M. & Schwarz, T., 2010, Key engineering materials. p. 789-792 (Key engineering materials).Research output: Chapter in Book/Report/Conference proceeding › Chapter › Research
- Published
Characterization of the fracture behavior of NBR and FKM grade elastomers for oilfield applications
Major, Z. & Lang, R., 2010, In: Engineering Failure Analysis. p. 701-711Research output: Contribution to journal › Article › Research › peer-review
- Published
Characterization of the global deformation behaviour of engineering plastics rolls
Berer, M. & Major, Z., 2010, In: International journal of mechanics and materials in design. p. 1-9Research output: Contribution to journal › Article › Research › peer-review
- Published
Charakterisierung des Einflusses von variierenden Prozessparametern beim Presssintern auf die Eigenschaften von ultrahochmolekularem Polyethylen (UHMWPE)
Haselwanter, D., 2010Research output: Thesis › Master's Thesis
- Published
Charakterisierung des Lichtstreuverhaltens und der Morphologie von thermotropen Verglasungen auf Thermoplastbasis
Seemann, M., 2010Research output: Thesis › Master's Thesis
- Published
Computational and experimental investigation of delamination in L-shaped laminated composite components
Wimmer, G., Kitzmüller, W., Pinter, G., Wettemann, T. & Pettermann, H. E., 2010, In: Engineering Fracture Mechanics. p. 2810-2820Research output: Contribution to journal › Article › Research › peer-review
- Published
Cyclic CRB Tests - A quick and reliable tool for ranking of PE pipe grades
Pinter, G., Frank, A., Redhead, A. & Lang, R. W., 2010, proceedings of Plastic Pipes XV Conference 2010. p. 1-8Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Cyclic bend tests for the reliability evaluation of printed circuit boards under dynamic loads
Fuchs, P. & Major, Z., 2010, In: Frattura ed Integrità Strutturale . 15, January, p. 64-73Research output: Contribution to journal › Article › Research › peer-review
