Department Polymer Engineering and Science
Organisational unit: Departments and Institutes
Research output
- 2010
- Published
Mathematical Modeling and Optimization of Run Parameters of Crystallization Analysis Fractionation (CRYSTAF)
Fischlschweiger, M., Aust, N., Oberaigner, E. & Kock, C., 2010, In: Macromolecular chemistry and physics. 211, p. 383-392Research output: Contribution to journal › Article › Research › peer-review
- Published
Mathematical modelling of the flow behaviour in the pressure build-up zone of a conical co-rotating twin screw extruder
Selvasankar, R. K., 2010.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Measurement of pressure dependent viscosity and its influence on injection molding simulation
Friesenbichler, W., Rajganesh Jegadeesan, X., Lucyshyn, T., Filz, P. & Webelhaus, K., 2010, 4th International PMI Conference - Conference Proceedings. p. 215-219Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Mechanische Charakterisierung eines glasfaserverstärkten UP-Werkstoffes
Guttmann, P. & Pinter, G., 2010Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
Mechanische Leistungssteigerung von Butadienkautschuken durch Modifizierung mit Carbon-Nanotubes
Mach, E. R., 2010Research output: Thesis › Master's Thesis
- Published
Mechanische und morphologische Untersuchungen an Polyolefin/Algen-Compounds
Feuchter, M. & Pinter, G., 2010Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
Method development for the reliability testing of printed circuit boards under dynamic loads
Major, Z. & Fuchs, P. F., 2010.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Modulation of the Chemical and Physical Properties of Thin Polymer Films via UV-light
Grießer, T., Edler, M., Köpplmayr, T., Muhr, N., Kern, W., Trimmel, G., Shen, Q., Teichert, C., Flesch, H-G., Marchl, M., Zojer, E., Resel, R., Sosa, G. H., Simbrunner, C., Sitter, H., Track, A., Koller, G. & Ramsey, M. G., 2010, Book of Abstracts. p. 48-48Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Molar mass distribution of several injection molded parts of PS and PP
Aust, N., 2010Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
Morphology of polyethylene ski base materials
Fischer, J., Wallner, G. & Pieber, A., 2010, In: Journal of sports sciences. 28, 5, p. 555-562Research output: Contribution to journal › Article › Research › peer-review
