Department Polymer Engineering and Science
Organisational unit: Departments and Institutes
Research output
- 2013
- Published
Cost-saving potentials for CFRP parts in early design stages
Horejsi, K., Noisternig, J., Koch, O. & Schledjewski, R., 2013.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Cost-saving potentials for CFRP parts in early design stages
Horejsi, K., Noisternig, J., Koch, O. & Schledjewski, R., 2013, Composite Materials: The great advance. p. 8439-8446Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Cross-linking of ROMP derived polymers using the two-photon induced thiol-ene reaction: towards the fabrication of 3D-polymer microstructures
Grießer, T., Wolfberger, A., Daschiel, U., Schmidt, V., Fian, A., Jerrar, A., Teichert, C. & Kern, W., 2013, In: Polymer Chemistry. 4, p. 1708-1714Research output: Contribution to journal › Article › Research › peer-review
- Published
Cure analysis of pultrusion epoxy resin
Kastanis, D., Feuchter, M., Moser, A., Wolfahrt, M., Pinter, G. & Schledjewski, R., 2013Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
DESIGN OF A DEMOLDING FORCE MEASUREMENT TOOL FOR INJECTION MOLDING
Struklec, T., Burgsteiner, M., Lucyshyn, T., Balika, W., Moderegger, S. & Holzer, C., 2013.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Deformation Analysis of an Automotive Part by Injection Molding Simulation: Influence of Material Data and Mold Modeling on Prediction Quality
Luger, H-J., Berger, G., Müller, F., Friesenbichler, W., Beytollahi, I. & Filz, P., 2013.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Deformation Analysis of an Automotive Part by Injection Molding Simulation: Influence of Material Data and Mold Modelling on Prediction Quality
Luger, H-J., Berger, G., Müller, F., Friesenbichler, W., Beytollahi, I. & Filz, P., 2013, 29th International Conference of the Polymer Processing Society. p. 59-59Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Deformation and Fracture Behavior of Semi-Crystalline Thermoplastics Used for Rolling Applications
Berer, M., 2013, 162 p.Research output: Thesis › Doctoral Thesis
- Published
Design of a Demolding Force Measurement Tool for Injection Molding
Struklec, T., Burgsteiner, M., Lucyshyn, T., Balika, W., Moderegger, S. & Holzer, C., 2013, Proceedings of the Polymer Processing Society 29th Annual Meeting ~ PPS-29. p. xxx-xxxResearch output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Determination of crack growth kinetics in non-reinforced semi-crystalline thermoplastics using the linear elastic fracture mechanics (LEFM) approach
Berer, M. & Pinter, G., 2013, In: Polymer Testing. 32, p. 870-879Research output: Contribution to journal › Article › Research › peer-review
