Department Polymer Engineering and Science
Organisational unit: Departments and Institutes
Research output
- 2013
- Published
INFLUENCE OF PROCESS SETTINGS ON THE TOPOGRAPHY OF SINK MARKS
Pacher, G., Berger, G., Gruber, D. P. & Friesenbichler, W., 2013, ADVANCES IN PLASTICS TECHNOLOGY - Conference Papers. Gliwice, Polen, p. Paper No. 31Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
INTERACTION BETWEEN INJECTION MOLDING PARAMETERS, FIBER ORIENTATION AND WARPAGE IN CARBON FIBER REINFORCED PPS VALVE PLATES
Lucyshyn, T., Janko, M., Schmid, M. & Holzer, C., 2013, Proceedings of the Polymer Processing Society 29th Annual Meeting ~ PPS-29. p. 1-4Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
INTERACTION BETWEEN INJECTION MOLDING PARAMETERS, FIBER ORIENTATION AND WARPAGE IN CARBON FIBER REINFORCED PPS VALVE PLATES
Lucyshyn, T., Janko, M., Schmid, M. & Holzer, C., 2013.Research output: Contribution to conference › Poster › Research › peer-review
- Published
INTERFACE CONDITIONS OF TWO-SHOT MOLDED PARTS
Kisslinger, T., Bruckmoser, K., Lucyshyn, T., Langecker, G. & Holzer, C., 2013.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Impact of varying between single and dual pressure butt-welding procedures for small scale pipes on short- and long-term fracture properties of PE 100 pipe welds
Arbeiter, F., 2013.Research output: Contribution to conference › Presentation › Research
- Published
Improvement of light shielding performance of thermotropic glazings by adaption of material composition and curing parameters
Weber, A. & Resch, K., 2013, Proceedings of the Austrian-Slovenian Polymer Meeting 2013. p. 132-133Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
In-Mold Sensor Concept to calculate process-specific Rheological Properties
Pacher, G., Berger, G., Friesenbichler, W., Gruber, D. P. & Macher, J., 2013, 29th International Conference of the Polymer Processing Society. p. 48-48Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
In-line cure monitoring of composite materials based on kinetic model analysis assisted by thermal sensing
Konstantopoulos, S., Tonejc, M., Fauster, E. & Schledjewski, R., 2013, Proceedings of the 5th ICSAAM. p. -Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Influence of Chain Extender on the Foaming Behavior and on the Mechanical Properteis of Physically Foamed PLA
Mostafa, H., Geißler, B., Uray, A., Laske, S., Holzer, C. & Langecker, G., 2013.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Influence of Mold Surface Temperature on Polymer Part Warpage in Rapid Heat Cycle Molding
Berger, G., Pacher, G., Gruber, D. P., Pichler, A. & Friesenbichler, W., 2013, 29th International Conference of the Polymer Processing Society. p. 49-49Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
