Department General, Analytical and Physical Chemistry
Organisational unit: Departments and Institutes
Research output
- 2013
- Published
Corrosion of Molybdenum in Cooling Water
Holzer, C., Vichytil, C., Mori, G. & Linke, C., 2013, Corrosion of Molybdenum in Cooling Water. p. 1-13Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Defect chemistry and oxygen exchange kinetics of mixed conducting perovskites for solid oxide fuel cell cathodes
Bucher, E., 2013Research output: Thesis › Habilitation thesis › peer-review
- Published
Determination of strontium isotope amount ratios in biological tissues using MC-ICPMS
Irrgeher, J., Prohaska, T., Sturgeon, R. E., Mester, Z. & Yang, L., 2013, In: Analytical Methods. 5, 7, p. 1687-1694Research output: Contribution to journal › Article › Research › peer-review
- Published
Efficiency of two gas and gas condensate inhibitors in a laboratory two phase flow
Prethaler, A., Vogl, T., Mori, G., Havlik, W., Zehethofer, G., Hönig, S. & Rosenberg, E., 2013, Efficiency of two gas and gas condensate inhibitors in a laboratory two phase flow. p. 1-12Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Enhanced oxygen surface exchange of La2NiO4+d by means of a thin surface layer of silver
Egger, A. & Sitte, W., 2013.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Enhancing oxygen surface exchange of rare earth nickelates
Egger, A. & Sitte, W., 2013.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Evaluation of two different Inhibitor Testing Methods for High Superficial Flow Conditions
Prethaler, A., Vogl, T., Mori, G., Havlik, W., Zehethofer, G. & Hönig, S., 2013, In: Berg- und hüttenmännische Monatshefte : BHM. 158, p. 371-376Research output: Contribution to journal › Article › Research › peer-review
- Published
Evaluation strategies for isotope ratio measurements of single particles by LA-MC-ICPMS
Prohaska, T., Boulyga, S. F. & Günther, D., 2013, In: Analytical and bioanalytical chemistry.Research output: Contribution to journal › Article › Research › peer-review
- Published
IMPACT OF INJECTION MOLDING PARAMETERS ON THE FIBERLENGTH DISTRIBUTION AND THE MECHANICAL PROPERTIES OF A SHORT CARBON FIBER REINFORCED POLYPHENYLENE SULFIDE
Janko, M., Lucyshyn, T., Schlögl, S., Raimann, P., Lenko, D., Meisel, T. & Holzer, C., 2013.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Impact of Condensates Containing Chloride and Sulphate on the Corrosion in Automotive Exhaust Systems
Hashimoto, R., 2013, In: Berg- und hüttenmännische Monatshefte : BHM. p. 377-383Research output: Contribution to journal › Article › Research › peer-review
