Chair of Simulation and Modelling of Metallurgical Processes (310)
Organisational unit: Chair
Research output
- Published
Cooperation within MEBSP on the Subject of Air Gap Formation during a Casting Process
Kron, J., Bellet, M., Ludwig, A., Wendt, J., Pustal, B. & Fredrikson, H., 2003, In: Advanced engineering materials. 5, p. 78-79Research output: Contribution to journal › Article › Research › peer-review
- Published
Microstructure Control by Solidification Processing – Outcome from a European Thematic Network
Lacaze, J., Greer, L., Howe, A., Ludwig, A. & Fredrikson, H., 2003, In: Advanced engineering materials. 5, p. 11-16Research output: Contribution to journal › Article › Research › peer-review
- Published
Influence of dendritic morphology on the calculation of macrosegregation in steel ingot
Li, J., Wu, M. H., Ludwig, A., Kharicha, A. & Schumacher, P., 1 Jan 2014, Solidification and Gravity VI. Trans Tech Publications, p. 121-126 6 p. (Materials Science Forum; vol. 790-791).Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Modelling macrosegregation in a 2.45 ton steel ingot
Li, J., Wu, M., Ludwig, A. & Kharicha, A., 2013, McWASP XIII. p. 1-1Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Simulation of channel segregation using a two-phase columnar solidification model, Part II: Mechanism and parameter study
Li, J., Wu, M., Hao, J., Kharicha, A. & Ludwig, A., 2012, In: Computational materials science. 55, p. 419-429Research output: Contribution to journal › Article › Research › peer-review
- Published
"Numerical study of macrosegregation in steel ingot"
Li, J. & Wu, M., 2013Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
Simulation of macrosegregation in a 2.45-ton steel ingot using a three-phase mixed columnar-equiaxed model
Li, J., Wu, M., Ludwig, A. & Kharicha, A., 2013, In: International journal of heat and mass transfer. 72.2014, May, p. 668-679 12 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Simulation of channel segregation using a two-phase columnar solidification model, Part I: Model description and verification
Li, J., Wu, M., Hao, J. & Ludwig, A., 2012, In: Computational materials science. 55, p. 407-418Research output: Contribution to journal › Article › Research › peer-review
- Published
Final Report on the short-term project "Simulation of solidification and macrosegregation in large round ingots produced by vertical continuous casting
Li, J., Wu, M. & Ludwig, A., 2013Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
Study of the channel segregation using a two-phase columnar solidification model
Li, J., Wu, M., Hao, J. & Ludwig, A., 2011, IOP Conf. Series: Mater. Sci. Eng., vol. 27. p. 1-7Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
