Chair of Polymer Processing (350)
Organisational unit: Chair
Research output
- 2013
- Published
Capabilities of a Demolding Force Measurement Tool for Injection Molding
Struklec, T., Holzer, C., Lucyshyn, T., Balika, W. & Moderegger, S., 2013, Proceedings of the Asia-Australasia Conference of PPS 2013. p. 051-051Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Charakterisierung der Entstehung des „Twist & Curl“ Effektes von Verbundmaterialformaten für die Getränkekartonherstellung
Mungenast, D., 2013, 94 p.Research output: Thesis › Master's Thesis
- Published
Charakterisierung und Weiterentwicklung von faserverstärkten Hochleistungsthermoplasten als Ventilplattenwerkstoffe
Koppelmüller, G., 2013Research output: Thesis › Master's Thesis
- Published
Compact Recreational Rebreather With Innovative Gas Sensing Concept and Low Work of Breathing Design
Sieber, A., Schuster, A., Reif, S., Kessler, M., Lucyshyn, T., Buzzacott, P. & Enoksson, P., 2013, In: Marine Technology Society journal. 47, 6, p. 27-41Research output: Contribution to journal › Article › Research › peer-review
- Published
Correlation between Rheotens Measurements and Reinforcement of Polymer Nanocomposites in the Injection Molding Compounder
Battisti, M., Duretek, I., Friesenbichler, W., Guttmann, P. & Pinter, G., 2013, 1st International Conference on Rheology and Modelling of Materials - Book of Abstracts. p. 39-39Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
DESIGN OF A DEMOLDING FORCE MEASUREMENT TOOL FOR INJECTION MOLDING
Struklec, T., Burgsteiner, M., Lucyshyn, T., Balika, W., Moderegger, S. & Holzer, C., 2013.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Deformation Analysis of an Automotive Part by Injection Molding Simulation: Influence of Material Data and Mold Modeling on Prediction Quality
Luger, H-J., Berger, G., Müller, F., Friesenbichler, W., Beytollahi, I. & Filz, P., 2013.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Deformation Analysis of an Automotive Part by Injection Molding Simulation: Influence of Material Data and Mold Modelling on Prediction Quality
Luger, H-J., Berger, G., Müller, F., Friesenbichler, W., Beytollahi, I. & Filz, P., 2013, 29th International Conference of the Polymer Processing Society. p. 59-59Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Design of a Demolding Force Measurement Tool for Injection Molding
Struklec, T., Burgsteiner, M., Lucyshyn, T., Balika, W., Moderegger, S. & Holzer, C., 2013, Proceedings of the Polymer Processing Society 29th Annual Meeting ~ PPS-29. p. xxx-xxxResearch output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Dielectric ResidenceTime Measurements on Single Screw Extruders
Schuschnigg, S., Reinberger, W., Holzer, C. & Fertschej, A., 2013, PPS-29 Polymer Processing Scociety. p. 31-31Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
