Chair of Physical Metallurgy (420)
Organisational unit: Chair
1171 - 1180 out of 2,139Page size: 10
Research output
- 2010
- Published
Charakterisierung des Ausscheidungs- und Korrosionsverhaltens von Lean-Duplex Stählen
Ragger, K., 2010, 111 p.Research output: Thesis › Diploma Thesis
- Published
Charakterisierung einer Pulvermetallurgisch hergestellten TNM TM-Titanaluminid Legierung mittels komplementärer quantitativer Methoden
Schloffer, M., Schmölzer, T., Mayer, S., Schwaighofer, E., Hawranek, G., Schimansky, F-P., Pyczak, F. & Clemens, H., 2010, Fortschritte in der Metallographie. Werkstoff-Informationsges., p. 239-244Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Combined structure-factor phase measurement and theoretical calculations for mapping of chemical bonds in GaN
Jiang, B., Zuo, J. M., Holec, D., Humphreys, C. J., Spackman, M. & Spence, C. H., 2010, In: Acta crystallographica / A (Section A, Foundations of crystallography). p. 446-450Research output: Contribution to journal › Article › Research › peer-review
- Published
Comparison of Ti1-XAlXN coatings deposited by reactive magnetron sputtering from powder metallurgical targets and from mosaic targets
Juri, N., 2010Research output: Thesis › Diploma Thesis
- Published
Control of phase formation during synthesis of ZrO2 coatings by magnetron sputtering
Walter, C., Mühlbacher, M. & Mitterer, C., 2010.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Crack resistance of hard coatings
Schlögl, M., Rovere, F. & Mayrhofer, P. H., 2010.Research output: Contribution to conference › Poster › Research › peer-review
- Published
DFT-based stacking fault energy in the Fe-22.5at.%Mn random alloy above room temperature
Reyes-Huamantinco, A., Ruban, A., Puschnig, P., Ambrosch-Draxl, C., Wießner, M., Wiener, J. & Ebner, R., 2010.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Development of intrinsic and thermal components of residual stress in nanostructured thin films: Grain size dependent phenomena
Daniel, R., Keckes, J. & Mitterer, C., 2010, Proceedings 8th European Conference on Residual Stresses. p. 15-15Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Dynamic Recovery and Recrystallization during Hot-Working in an advanced tial alloy
Schmölzer, T., Liss, K-D., Rester, M., Yan, K., Stark, A., Reid, M., Peel, M. & Clemens, H., 2010, Fortschritte in der Metallographie. Werkstoff-Informationsges., p. 215-220Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Effect of Cu on the evolution of precipitation in an Fe-Cr-Ni-Al-Ti maraging steel
Schnitzer, R., Schober, M., Zinner, S. & Leitner, H., 2010, In: Acta materialia. 58, p. 3733-3741Research output: Contribution to journal › Article › Research › peer-review
