Chair of Physical Metallurgy (420)
Organisational unit: Chair
Research output
- 2010
- Published
Crack resistance of hard coatings
Schlögl, M., Rovere, F. & Mayrhofer, P. H., 2010.Research output: Contribution to conference › Poster › Research › peer-review
- Published
DFT-based stacking fault energy in the Fe-22.5at.%Mn random alloy above room temperature
Reyes-Huamantinco, A., Ruban, A., Puschnig, P., Ambrosch-Draxl, C., Wießner, M., Wiener, J. & Ebner, R., 2010.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Development of intrinsic and thermal components of residual stress in nanostructured thin films: Grain size dependent phenomena
Daniel, R., Keckes, J. & Mitterer, C., 2010, Proceedings 8th European Conference on Residual Stresses. p. 15-15Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Dynamic Recovery and Recrystallization during Hot-Working in an advanced tial alloy
Schmölzer, T., Liss, K-D., Rester, M., Yan, K., Stark, A., Reid, M., Peel, M. & Clemens, H., 2010, Fortschritte in der Metallographie. Werkstoff-Informationsges., p. 215-220Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Effect of Cu on the evolution of precipitation in an Fe-Cr-Ni-Al-Ti maraging steel
Schnitzer, R., Schober, M., Zinner, S. & Leitner, H., 2010, In: Acta materialia. 58, p. 3733-3741Research output: Contribution to journal › Article › Research › peer-review
- Published
Effect of Grain Size on the Residual Stress State and Thermal Expansion in Magnetron Sputtered Thin Films
Daniel, R., Holec, D., Keckes, J. & Mitterer, C., 2010, Proceedings 37th International Conference on Metallurgical Coatings and Thin Films. p. 63-63Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Effect of process modeling on product quality of superalloy forgings
Stockinger, M., Riedler, M. & Huber, D., 2010, 7th International Symposium on Superalloy 718 and Derivatives 2010. p. 183-197 15 p. (7th International Symposium on Superalloy 718 and Derivatives 2010; vol. 1).Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Einfluss der Pulverfraktion auf die Eigenschaften von pulvermetallurgisch hergestelltem Schnellarbeitsstahl
Zuber, M., Winkler, H., Schweiger, H. & Leitner, H., 2010, In: Berg- und hüttenmännische Monatshefte : BHM. 155, p. 136-141Research output: Contribution to journal › Article › Research › peer-review
- Published
Einfluss der bainitischen Umwandlung auf die mechanischen Eigenschaften von Warmarbeitsstählen
Mayer, S., 2010, In: Berg- und hüttenmännische Monatshefte : BHM. p. 388-393Research output: Contribution to journal › Article › Research › peer-review
- Published
Einfluss von Silizium auf Struktur und mechanische Eigenschaften von nitrierten Randzonen in 5% Cr martensitischen Stählen
Ognianov, M., 2010Research output: Thesis › Diploma Thesis
