Chair of Electrical Engineering (240)
Organisational unit: Chair
Research output
- 2013
- Published
Optimization of Permanent Magnet Synchronous Machine Design
Weiß, H., Aschenbrenner, F. & Czernin, W., 2013, EDPE 2013. p. 79-83Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Practical Experience and Consequences from 200 km Drive with Electric Vehicle Operated by Used Batteries
Weiß, H. & Weiss, H. J., 2013, EDPE 2013. p. 83-89Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Sicheres Energieversorgungssystem mit PV - Überschusseinspeiser und örtliche Energiezwischenspeicherung in Batterien
Steininger, D., 2013Research output: Thesis › Master's Thesis
- Published
Six Phase Permanent Magnet Machine with Fractional Slot Concentrated Winding
Krall, R., Krenn, J. & Weiss, H., 2013, Proceedings - EDPE 2013. p. 26-31Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Verification of Mathematical Model of Complex Controlled Drive System through On-Site Measurement of Mechanical Signals
Weiß, H., Bastos, I. & Hofstätter, H., 2013, EDPE 2013. p. 221-226Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Verification of Mathematical Model of Complex Controlled Drive System through On-Site Measurement of Mechanical Signals
Weiß, H., Bastos, I. & Hofstätter, H., 2013.Research output: Contribution to conference › Poster › Research › peer-review
- 2012
- Published
Functional Mold Coatings for Dynamic Mold Surface Temperature Control in Injection Molding. Simulation of Joule Heating of Thin Films and Development of a Test System.
Pacher, G., Berger, G., Friesenbichler, W. & Weiß, H., 2012, Abstract Book - The 28th International Conference of Polymer Processing Society (PPS-28). p. 495-495Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Functional Mold Coatings for Dynamic Mold Surface Temperature Control in Injection Molding. Simulation of Joule Heating of Thin Films and Development of a Test System.
Pacher, G., Berger, G., Friesenbichler, W. & Weiß, H., 2012.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Gesamtsystemoptimierung eines Antriebs für batteriegespeiste Elektrofahrzeuge
Kaserer, G., 2012Research output: Thesis › Doctoral Thesis
- Published
Re-Use von Lithium-Ionen-Zellen und -Modulen aus Elektrofahrzeug-Batterien
Weiß, H. & Arnberger, A., 2012, DepoTech 2012, Abfallwirtschaft, Abfalltechnik, Deponietechnik und Altlasten. p. 599-602Research output: Chapter in Book/Report/Conference proceeding › Chapter › Research
