Chair of Casting Research (330)
Organisational unit: Chair
31 - 40 out of 434Page size: 10
Research output
- Published
Evaluation of a mixed columnar-equiaxed solidification model with laboratory castings
Wu, M., Nunner, G., Ludwig, A., Li, J. & Schumacher, P., 2011, IOP Conf. Series: Mater. Sci. Eng., vol. 27. p. 1-7Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Phase Selection in 6082 Al-Mg-Si Alloys
Wimmer, A. C., Li, J. & Schumacher, P., 2012, In: Berg- und hüttenmännische Monatshefte : BHM. p. 301-305Research output: Contribution to journal › Article › Research › peer-review
- Published
Influence of the homogenization treatment on the precipitation and dissolution of intermetallic phases and effects on extrudability in direct chilled Al-Mg-Si alloys
Wimmer, A. C., 2011, 112 p.Research output: Thesis › Diploma Thesis
- Published
Stress/Strain Behaviour and Fatigue Limit of Grey Cast Iron
Willidal, T., Bauer, W. & Schumacher, P., 2005, In: Materials science and engineering: A, Structural materials: properties, microstructure and processing. p. 578-582Research output: Contribution to journal › Article › Research › peer-review
- Published
Spannungs/Dehnungs-Verhalten und Schwingfestigkeit von Gusseisen mit Lamellengraphit
Willidal, T., 2007, 265 p.Research output: Thesis › Doctoral Thesis
- Published
Computertomographie
Wenzl, B., Schumacher, P. & Geier, G., 2010.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Bestimmung der Aufnahmegrenzen bei Computertomographieuntersuchungen
Wenzl, B., 2008Research output: Thesis › Master's Thesis
- Published
Aging Behavior of Nano-SiC/2014Al Composite Fabricated by Powder Metallurgy and Hot Extrusion Techniques
Wang, Z., Li, C., Wang, H., Zhu, X., Wu, M., Li, J. & Jiang, Q., 2016, In: JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY. 32 (10), p. 1008 1012 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Corrosion behavior of as-cast Mg-5Sn based alloys with In additions in 3.5 wt% NaCl solution.
Wang, X. J., Chen, Z. N., Ren, J., Kang, H. J., Guo, E. Y., LI, J. & Wang, T. M., Mar 2020, In: Corrosion science. 164.2020, March, p. 108318 11 p., 108318.Research output: Contribution to journal › Article › Research › peer-review
- Published
Thermal physical and mechanical properties of raw sands and sand cores for aluminum casting
Wang, X., 2014Research output: Thesis › Master's Thesis
