Investigation of the crude oil/brine interaction through interfacial viscoelasticity and microdispersion

Research output: ThesisMaster's Thesis

Bibtex - Download

@mastersthesis{6dce7c1fe4e4486799b9986980a04d84,
title = "Investigation of the crude oil/brine interaction through interfacial viscoelasticity and microdispersion",
abstract = "Smart waterflooding in hydrocarbon reservoirs has been a topic of profound conjecture. Several recovery mechanisms have been proposed for the process, including wettability alteration toward water-wetness. On the other hand, less attention has been given to the fluid-fluid interactions. The long-held hypothesis that the Low Salinity Effect (LSE) depends mainly on rock and fluid interactions has led to occasional failures that fluid-fluid interactions can explain. Therefore, improving our knowledge about the microscopic interactions in the crude oil/brine/rock systems appears to be vital. In this study, the emphasis is on the two fluid/fluid mechanisms proposed recently, namely the interfacial viscoelasticity and microdispersion. Hence, interface viscoelasticity and formation of water in oil microdispersions are investigated experimentally and analytically. The impact of the aqueous phase ionic strength and ionic composition are examined on the viscoelastic properties of the crude oil/brine interfacial film by conducting interfacial dilatational rheological measurements under controlled water chemistry. Interfacial viscoelasticity measurements were conducted on three Austrian crude oils. In general, the viscoelastic properties of the interface have a reverse relationship with the brine salinity reduced no matter what type of ions are present in the brine. However, the rate of elasticity build-up depends upon specific ions present in the solution as well as crude oil properties. The interface viscoelasticity for NaCl solutions and crude oil increased continuously as the salt concentration decreased. However, it increased non-monotonically until a maximum in viscoelasticity was observed, at 10,000 ppm for a pure solution NaCl with 2.5% Na2SO4. The interfacial film response depends on the combined characteristics of crude oil and water and the aging time between two fluids. A good correlation was developed for the oil property, namely, the acidic component and the oil viscosity and interfacial mechanical moduli. This correlation might indicate that the adsorption of polar materials onto the interface can be considered a diffusion-like process. The analytical investigation of the available microdispersion data from the literature revealed the importance of crude oil acidic components as the main contributing factor in the formation of water in oil microdispersions. Furthermore, the total brine salinity was determined as the main factor regarding the brine properties with a negative correlation factor. Thus, the outcomes of the statistical investigation of the microdispersion ratio were in agreement with the observations done in the literature, whereby the oil acidic components were detected as the main crude oil fractions contributing to the microdispersion formation.",
keywords = "Enhanced Oil Recovery, Low Salinity Water, Interfacial Viscoelasticity, Micro Dispersion Ratio, Erh{\"o}hte {\"O}lgewinnung, niedrig salines Wasser, Dilatationale Grenzfl{\"a}chenviskoelastizit{\"a}t, Mikrodispersionsverh{\"a}ltnis",
author = "Peyman Nazifi",
note = "embargoed until null",
year = "2021",
language = "English",
school = "Montanuniversitaet Leoben (000)",

}

RIS (suitable for import to EndNote) - Download

TY - THES

T1 - Investigation of the crude oil/brine interaction through interfacial viscoelasticity and microdispersion

AU - Nazifi, Peyman

N1 - embargoed until null

PY - 2021

Y1 - 2021

N2 - Smart waterflooding in hydrocarbon reservoirs has been a topic of profound conjecture. Several recovery mechanisms have been proposed for the process, including wettability alteration toward water-wetness. On the other hand, less attention has been given to the fluid-fluid interactions. The long-held hypothesis that the Low Salinity Effect (LSE) depends mainly on rock and fluid interactions has led to occasional failures that fluid-fluid interactions can explain. Therefore, improving our knowledge about the microscopic interactions in the crude oil/brine/rock systems appears to be vital. In this study, the emphasis is on the two fluid/fluid mechanisms proposed recently, namely the interfacial viscoelasticity and microdispersion. Hence, interface viscoelasticity and formation of water in oil microdispersions are investigated experimentally and analytically. The impact of the aqueous phase ionic strength and ionic composition are examined on the viscoelastic properties of the crude oil/brine interfacial film by conducting interfacial dilatational rheological measurements under controlled water chemistry. Interfacial viscoelasticity measurements were conducted on three Austrian crude oils. In general, the viscoelastic properties of the interface have a reverse relationship with the brine salinity reduced no matter what type of ions are present in the brine. However, the rate of elasticity build-up depends upon specific ions present in the solution as well as crude oil properties. The interface viscoelasticity for NaCl solutions and crude oil increased continuously as the salt concentration decreased. However, it increased non-monotonically until a maximum in viscoelasticity was observed, at 10,000 ppm for a pure solution NaCl with 2.5% Na2SO4. The interfacial film response depends on the combined characteristics of crude oil and water and the aging time between two fluids. A good correlation was developed for the oil property, namely, the acidic component and the oil viscosity and interfacial mechanical moduli. This correlation might indicate that the adsorption of polar materials onto the interface can be considered a diffusion-like process. The analytical investigation of the available microdispersion data from the literature revealed the importance of crude oil acidic components as the main contributing factor in the formation of water in oil microdispersions. Furthermore, the total brine salinity was determined as the main factor regarding the brine properties with a negative correlation factor. Thus, the outcomes of the statistical investigation of the microdispersion ratio were in agreement with the observations done in the literature, whereby the oil acidic components were detected as the main crude oil fractions contributing to the microdispersion formation.

AB - Smart waterflooding in hydrocarbon reservoirs has been a topic of profound conjecture. Several recovery mechanisms have been proposed for the process, including wettability alteration toward water-wetness. On the other hand, less attention has been given to the fluid-fluid interactions. The long-held hypothesis that the Low Salinity Effect (LSE) depends mainly on rock and fluid interactions has led to occasional failures that fluid-fluid interactions can explain. Therefore, improving our knowledge about the microscopic interactions in the crude oil/brine/rock systems appears to be vital. In this study, the emphasis is on the two fluid/fluid mechanisms proposed recently, namely the interfacial viscoelasticity and microdispersion. Hence, interface viscoelasticity and formation of water in oil microdispersions are investigated experimentally and analytically. The impact of the aqueous phase ionic strength and ionic composition are examined on the viscoelastic properties of the crude oil/brine interfacial film by conducting interfacial dilatational rheological measurements under controlled water chemistry. Interfacial viscoelasticity measurements were conducted on three Austrian crude oils. In general, the viscoelastic properties of the interface have a reverse relationship with the brine salinity reduced no matter what type of ions are present in the brine. However, the rate of elasticity build-up depends upon specific ions present in the solution as well as crude oil properties. The interface viscoelasticity for NaCl solutions and crude oil increased continuously as the salt concentration decreased. However, it increased non-monotonically until a maximum in viscoelasticity was observed, at 10,000 ppm for a pure solution NaCl with 2.5% Na2SO4. The interfacial film response depends on the combined characteristics of crude oil and water and the aging time between two fluids. A good correlation was developed for the oil property, namely, the acidic component and the oil viscosity and interfacial mechanical moduli. This correlation might indicate that the adsorption of polar materials onto the interface can be considered a diffusion-like process. The analytical investigation of the available microdispersion data from the literature revealed the importance of crude oil acidic components as the main contributing factor in the formation of water in oil microdispersions. Furthermore, the total brine salinity was determined as the main factor regarding the brine properties with a negative correlation factor. Thus, the outcomes of the statistical investigation of the microdispersion ratio were in agreement with the observations done in the literature, whereby the oil acidic components were detected as the main crude oil fractions contributing to the microdispersion formation.

KW - Enhanced Oil Recovery

KW - Low Salinity Water

KW - Interfacial Viscoelasticity

KW - Micro Dispersion Ratio

KW - Erhöhte Ölgewinnung

KW - niedrig salines Wasser

KW - Dilatationale Grenzflächenviskoelastizität

KW - Mikrodispersionsverhältnis

M3 - Master's Thesis

ER -