Fracture of Thin-Walled Polyoxymethylene Bulk Specimens in Modes I and III
Research output: Contribution to journal › Article › Research › peer-review
Standard
In: Materials, Vol. 13, No. 22, 5096, 02.11.2020, p. 1-18.
Research output: Contribution to journal › Article › Research › peer-review
Harvard
APA
Vancouver
Author
Bibtex - Download
}
RIS (suitable for import to EndNote) - Download
TY - JOUR
T1 - Fracture of Thin-Walled Polyoxymethylene Bulk Specimens in Modes I and III
AU - Schrader, Peer
AU - Gosch, Anja
AU - Berer, Michael
AU - Marzi, Stephan
PY - 2020/11/2
Y1 - 2020/11/2
N2 - Thin-walled polymeric components are used in many applications. Hence, knowledge about their fracture behavior in bulk is beneficial in practice. Within this study, the double cantilever beam (DCB) and out-of-plane double cantilever beam (ODCB) tests are enhanced to enable the testing of such bulk specimens in mode I and mode III on the basis of the J-integral. This paper then presents and discusses the experimental results following the investigation of a semicrystalline polymer (polyoxymethylen) under quasi-static load conditions. From the experiments, fracture energies of similar magnitude in both mode I and mode III were determined. In mode III, pop-in fracture was observed. Furthermore, the fracture surfaces were investigated regarding the mode I and mode III dominant crack growth mechanisms, based on the morphology of the tested material. For specimens tested in mode I, no signs of plastic deformation were observed, and the fracture surface appears flat. In mode III, some samples display a twisted fracture surface (twisting angle close to 45 ◦ ), which indicates local mode I crack growth. A transfer of the presented methodology to other (more ductile) polymeric materials is deemed possible without further restrictions. In addition, the presented setup potentially enables an investigation of polymeric bulk specimens in mixed mode I+III.
AB - Thin-walled polymeric components are used in many applications. Hence, knowledge about their fracture behavior in bulk is beneficial in practice. Within this study, the double cantilever beam (DCB) and out-of-plane double cantilever beam (ODCB) tests are enhanced to enable the testing of such bulk specimens in mode I and mode III on the basis of the J-integral. This paper then presents and discusses the experimental results following the investigation of a semicrystalline polymer (polyoxymethylen) under quasi-static load conditions. From the experiments, fracture energies of similar magnitude in both mode I and mode III were determined. In mode III, pop-in fracture was observed. Furthermore, the fracture surfaces were investigated regarding the mode I and mode III dominant crack growth mechanisms, based on the morphology of the tested material. For specimens tested in mode I, no signs of plastic deformation were observed, and the fracture surface appears flat. In mode III, some samples display a twisted fracture surface (twisting angle close to 45 ◦ ), which indicates local mode I crack growth. A transfer of the presented methodology to other (more ductile) polymeric materials is deemed possible without further restrictions. In addition, the presented setup potentially enables an investigation of polymeric bulk specimens in mixed mode I+III.
KW - Experimental procedures
KW - Fracture mechanical testing
KW - J-integral
KW - Polymers
KW - Polyoxymethylene
KW - Quasi-static loads
KW - Tensile and shear dominated fracture
UR - http://www.scopus.com/inward/record.url?scp=85096709671&partnerID=8YFLogxK
U2 - 10.3390/ma13225096
DO - 10.3390/ma13225096
M3 - Article
VL - 13
SP - 1
EP - 18
JO - Materials
JF - Materials
SN - 1996-1944
IS - 22
M1 - 5096
ER -