Departments and Chairs
Organisational unit: Departments and Institutes
171 - 180 out of 33,496Page size: 10
Research output
- Published
Einfluss der Unternehmenskultur auf die Zielfindung von Unternehmen des Investitionsgütersektors
Zimmermann, J., 2017Research output: Thesis › Master's Thesis
- Published
Matrix separation of Sr and Pb for isotopic ratio analysis of Ca-rich samples via an automated simultaneous separation procedure
Zimmermann, T., Retzmann, A., Schober, M., Pröfrock, D., Prohaska, T. & Irrgeher, J., 1 Jan 2019, In: Spectrochimica Acta - Part B Atomic Spectroscopy. 151.2019, January, p. 54-64 11 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Zinc isotopic variation of water and surface sediments from the German Elbe River
Zimmermann, T., Mohamed, A. F., Reese, A., Wieser, M. E., Kleeberg, U., Proefrock, D. & Irrgeher, J., 10 Mar 2020, In: Science of the total environment. 707, 135219.Research output: Contribution to journal › Article › Research › peer-review
- Published
Design and development of a novel fuel sensor
Zillner, C., 2014Research output: Thesis › Master's Thesis
- Published
Analyse produktions- und anlagennaher Managementkonzepte nach funktionalen und organisationskulturellen Aspekten
Zielowski, C., 2005Research output: Thesis › Doctoral Thesis
- Published
Preheating of austenitic stainless steel for cold forming
Zielbauer, F., 2018Research output: Thesis › Master's Thesis
- Published
Investigation of the binding-sulfide layer formation on brass-coated steel wires using squalene as low-molecular model compound for NR
Ziegler, E., Gruber, D., Kern, W., Feldgitscher, C., Holzner, A. & Trimmel, G., 2010.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Investigation of the influence of stearic acid on rubber-brass adhesion
Ziegler, E., Macher, J., Gruber, D. P., Pölt, P., Kern, W., Lummerstorfer, T., Feldgitscher, C., Holzner, A. & Trimmel, G., 2011, In: Rubber chemistry and technology. 85, 2, p. 264 - 276Research output: Contribution to journal › Article › Research › peer-review
- Published
Neuartige Elastomerwerkstoffe auf Basis von Nanocompositen
Ziegler, W., Rieß, G. (Co-editor), Winter, J. (Co-editor), Kopeinig, S. (Co-editor), Dietrich, M. (Co-editor), Resch-Fauster, K. (Co-editor), Kern, W. (Co-editor) & Pinter, G. (Co-editor), 14 Apr 2016, 25. Leobener Kunststoff-Kolloquium: Kunststoffgerechte Bauteilentwicklung - vom Werkstoff zum Produkt: Schriftenreihe Kunststofftechnik Leoben. Pinter, G. & Pilz, G. (eds.). Leoben, Vol. 6. p. 209-210 2 p.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
New elastomers based on polyurethanes
Ziegler, W., Winter, J. (Co-editor), Rieß, G., Kopeinig, S. (Co-editor), Dietrich, M. (Co-editor), Resch-Fauster, K. (Co-editor), Kern, W. (Co-editor) & Pinter, G. (Co-editor), 9 Mar 2015.Research output: Contribution to conference › Poster › Research › peer-review
