Departments and Chairs
Organisational unit: Departments and Institutes
2021 - 2030 out of 33,522Page size: 10
Research output
- Published
Investigation of the dynamic mechanical behavior of Polyetheretherketone (PEEK) in the high stress tensile regime
Berer, M., Major, Z., Pinter, G., Constantinescu, D. M. & Marsavina, L., 2014, In: Mechanics of time-dependent materials. 18, p. 663-684Research output: Contribution to journal › Article › Research › peer-review
- Published
Influence of post processing change of the fracture mechanical properties of polyoxymethylene (POM)
Berer, M., Feuchter, M. & Pinter, G., 2015, PPS2015 - Book of Abstract.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- E-pub ahead of print
Dynamic mechanical response of polyetheretherketone (PEEK) exposed to cyclic loads in the high stress tensile regime
Berer, M., Tscharnuter, D. & Pinter, G., 3 Jul 2016, (E-pub ahead of print) In: International Journal of Fatigue. 80.2015, October, p. 397-405 9 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Deformation and Fracture Behavior of Semi-Crystalline Thermoplastics Used for Rolling Applications
Berer, M., 2013, 162 p.Research output: Thesis › Doctoral Thesis
- Published
Charakterisierung und Simulation des Verformungsverhaltens von Kunststoffrollen aus POM und PEEK
Berer, M., 2007Research output: Thesis › Diploma Thesis
- E-pub ahead of print
Finite element study of mode I crack opening effects in compression-loaded cracked cylinders
Berer, M., Mitev, I. & Pinter, G. G., 10 Mar 2017, (E-pub ahead of print) In: Engineering Fracture Mechanics. 175.2017, 15 April, p. 1-14 14 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Finite element study of mode I crack opening effects in compression-loaded cracked cylinders
Berer, M., Mitev, I. & Pinter, G. G., 2017.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Fatigue Fracture Properties and Morphology of Polyoxymethylene (POM) Plates Produced under Moderate Processing Conditions
Berer, M., Halb, M., Feuchter, M., Pacher, G. & Pinter, G., 4 Nov 2018, In: International journal of polymer science . 2018, 18 p., 7410925.Research output: Contribution to journal › Article › Research › peer-review
- Published
Anforderungen an die Aufbereitung von Polyamid-Altpulver zur Wiederverwendung im SLS Prozess
Berer, M., Schrank, T., Hendlich, M., Meier, G., Arbeiter, F., Lackner, J. & Kraschitzer, W., 20 Apr 2018.Research output: Contribution to conference › Paper
- Published
Fatigue fracture properties and morphology of Polyoxymethylene (POM) plates produced under moderate processing conditions
Berer, M., Halb, M., Feuchter, M., Pacher, G. & Pinter, G. G., 2018.Research output: Contribution to conference › Poster › Research
