Department Mineral Resources Engineering
Organisational unit: Departments and Institutes
Research output
- 2016
- Published
New Test Stand to optimize Segments for mechanized Tunnelling
Gehwolf, P., Wenighofer, R., Barwart, S., Galler, R., Haberler-Weber, M., Moritz, B., Barwart, C. & Lange, A., Feb 2016, In: GeoResources Zeitschrift. 2016, 2, p. 21-25 5 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Recent Research Activities of the Chair of Mineral Processing regarding Electrostatic Separation
Flachberger, H., Mirkowska, M. & Lämmerer, W., 29 Jan 2016.Research output: Contribution to conference › Presentation › Research
- E-pub ahead of print
Thermomechanical failure modeling and investigation into lining optimization for a Ruhrstahl Heraeus snorkel
Jin, S., Gruber, D., Harmuth, H. & Rössler, R., 28 Jan 2016, (E-pub ahead of print) In: Engineering Failure Analysis. 62.2016, April, p. 254-262 9 p.Research output: Contribution to journal › Article › Research › peer-review
- E-pub ahead of print
3D numerical study on microwave induced stresses in inhomogeneous hard rocks
Toifl, M., Meisels, R., Hartlieb, P., Kuchar, F. & Antretter, T., 18 Jan 2016, (E-pub ahead of print) In: Minerals engineering. 90.2016, May, p. 29-42 14 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Tensile creep measurements of ordinary ceramic refractories at service related loads including setup, creep law, testing and evaluation procedures
Sidi Mammar, A., Gruber, D., Harmuth, H. & Jin, S., 14 Jan 2016, In: Ceramics International : CI. 42.2016, 1 May, p. 6791-6799 9 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Reply to Discussion of "The Case for the Median Fragment Size as a Better Fragmenst Size Descriptor than the Mean", RMRE artcile
Ouchterlony, F., Jan 2016, In: Rock mechanics and rock engineering. 49, 1, p. 339-342 4 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
2D Versus 3D Liberation Analysis to Characterize Intergrowth in LD Slags
Böhm, A. & Niiranen, K., 2016, Conference Proceedings of the XXVIII International Mineral Processing Congress. Quebec, Canada, 553Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
2D versus 3D Liberation Analysis to Characterize InItergrowth in LD Slags
Böhm, A., 2016.Research output: Contribution to conference › Presentation › Research › peer-review
- Published
Alternative methods in hard rock cutting
Hartlieb, P., Grafe, B. & Drebenstedt, C., 2016, 13th international symposium continuous surface mining. p. 115-126Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
An Investigation into the Excess Haulage Capacity at Greenside Colliery’s Thandeka Section using Computer Simulation
Smith, P. E., 2016Research output: Thesis › Master's Thesis (University Course)
