Chair of Polymer Processing (350)
Organisational unit: Chair
Research output
- 2009
- Published
Polymere Nanocomposites
Laske, S., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Pressure dependent viscosity and its importance for injection molding simulations
Rajganesh Jegadeesan, X., Friesenbichler, W., Duretek, I., Filz, P. & Webelhaus, K., 2009, Conference Proceedings. p. 217-222Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Replication of a draw-polished cavity surface into PP and PC. Influence of flow length, wall thickness and injection molding parameters
Burgsteiner, M., Berger, G. & Friesenbichler, W., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Replication of a draw-polished cavity surface into PP and PC. Influence of flow length, wall thickness and injection molding parameters
Burgsteiner, M., Berger, G. & Friesenbichler, W., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Rheologische Analyse
Duretek, I., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Semi-industrial approach for wear measurement in injection moulds
Friesenbichler, W. & Oláh, L., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Simulation Aufheizprozess Thermoformen
Fertschej, A., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Simulation des Aufheizprozesses
Fertschej, A., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Simulation von Extrusionswerkzeugen
Fertschej, A., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Spritzgießsimulation
Lucyshyn, T., 2009.Research output: Contribution to conference › Poster › Research › peer-review
