Chair of Polymer Processing (350)
Organisational unit: Chair
Research output
- 2011
- Published
Influence of processing conditions and induced shear work on the thermal, rheological and mechanical behavior of polymer nanocomposites
Mattausch, H., Laske, S., Duretek, I., Witschnigg, A. & Holzer, C., 2011,Program & Abstracts of 27th Annual Meeting of the Polymer Processing Society
. p. 157-158Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Influence of shear energy on the properties of polyolefin nanocomposite pipes: Plastics Research Online, Reihentitel: 10.1002/spepro.003977
Witschnigg, A., Laske, S., Kracalik, M. & Holzer, C., 2011Research output: Non-textual form › Web publication/site › Transfer
- Published
Influence of the degree of exfoliation on the thermal conductivity of polypropylene nanocomposites
Laske, S., Duretek, I., Witschnigg, A. & Holzer, C., 2011,Program & Abstracts of 27th Annual Meeting of the Polymer Processing Society
. p. 155-155Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Influence of the heat transfer coefficient on the injection molding simulation of microstructures
Müller, F., Lucyshyn, T., Kukla, C. & Holzer, C., 2011, Conference Proceedings - ICIT & MPT 2011 . p. 141-148Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Investigations of adhesion on two-shot moulded parts
Kisslinger, T., Lucyshyn, T., Doler, M., Langecker, G. & Holzer, C., 2011.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Kunststoffverarbeitung-Vom Rohstoff zum fertigen Bauteil
Piontek, M., Holzer, C. & Laske, S., 2011.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Local structure around nano-clay agglomerates in PP composites – a scanning X-Ray diffraction study with sub micron resolution
Feuchter, M., Maier, G. A., Burghammer, M., Kracalik, M., Laske, S., Keckes, J. & Pinter, G., 2011, European Polymer Congress 2011. p. 515-515Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Measurement of the visual perceptibility of sink marks in injection molded parts
Haba, D., 2011, 79 p.Research output: Thesis › Master's Thesis
- Published
Measuring the pressure dependent viscosity at high shear rates using a new rheological injection mould
Friesenbichler, W., Duretek, I., Rajganesh Jegadeesan, X. & Selvasankar, R. K., 2011, In: Polimery/Polymers. 56, 1, p. 58-62Research output: Contribution to journal › Article › Research › peer-review
- Published
