Chair of Polymer Processing (350)
Organisational unit: Chair
181 - 190 out of 930Page size: 10
Research output
- 2020
- Published
Development of Ceramic Feedstocks for Fused Filament Fabrication
Cano Cano, S., 2020Research output: Thesis › Doctoral Thesis
- Published
Development of a PAT-controlled process for the production of pharmaceutical polymers with low drug concentration
Heindl, N., 2020Research output: Thesis › Master's Thesis
- Published
Process validation and optimization of a two-step two-component direct bonding between thermoplastic and rubber
Huber, S., 2020Research output: Thesis › Master's Thesis
- Published
Production of multimaterial components by material extrusion - Fused filament fabrication (ME-FFF)
Kukla, C., Cano, S., Moritz, T., Müller-Köhn, A., Günther, A., Hampel, S. & Holzer, C., 2020, Euro PM 2018 Congress and Exhibition. (Euro PM 2018 Congress and Exhibition).Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Accepted/In press
Structural integrity of shrinkage and warpage optimized polypropylene produced by material extrusion-based additive manufacturing
Petersmann, S., Spörk, M., Wiener, J., Pinter, G. G. & Arbeiter, F., 2020, (Accepted/In press).Research output: Contribution to conference › Abstract › peer-review
- 2019
- Published
Determination of residual moisture on four composite films
Duretek, I. & Winkler, S., 17 Dec 2019, 4 p.Research output: Book/Report › Commissioned report › Research
- Published
Material data determination for one MIM-feedstock for injection molding simulation
Duretek, I., 17 Dec 2019, 13 p.Research output: Book/Report › Commissioned report › Research
- Published
Destroying or Enhancing the Mechanical Properties of Carbon Fibre Filled PA12 filaments for Additive Manufacturing?
Holzer, C., Gonzalez-Gutierrez, J., Cano Cano, S., Schuschnigg, S., Arbeiter, F., Liu, D., Wuzella, G. H. & Lammer, H., 7 Nov 2019, p. 59-59. 1 p.Research output: Contribution to conference › Abstract › peer-review
- Published
Influence of stearic acid in feedstocks for FFF and PIM
Kukla, C., Cano Cano, S., Holzer, C. & Gonzalez-Gutierrez, J., 16 Oct 2019.Research output: Contribution to conference › Paper › peer-review
- E-pub ahead of print
Material extrusion-based additive manufacturing of polypropylene: A review on how to improve dimensional inaccuracy and warpage
Spörk, M., Holzer, C. & Gonzalez-Gutierrez, J., 15 Oct 2019, (E-pub ahead of print) In: Journal of applied polymer science. 137.2020, 12, 16 p., 48454.Research output: Contribution to journal › Review article › peer-review
