Chair of Polymer Processing (350)
Organisational unit: Chair
221 - 230 out of 946Page size: 10
Research output
- Published
Heizzeitverkürzung für den Elastomerspritzguss mittels eines Heiz-Scher-Mischteiles
Perko, L., 2009Research output: Thesis › Master's Thesis
- Published
Functionally graded additive manufacturing
Pei, E., Rumana Kabir, I., Godec, D., Gonzalez-Gutierrez, J. & Nordin, A., 9 Apr 2021, Additive Manufacturing with Functionalized Nanomaterials: Micro and Nono Technologies. Amsterdam, Neterlands: Elsevier, p. 35-54 20 p.Research output: Chapter in Book/Report/Conference proceeding › Chapter › Research
- Published
Compoundierung von Filamenten für medizinische FFF-Anwendungen
Payr, B., 2016Research output: Thesis › Master's Thesis
- Published
Supportless lattice structure of 316L stainless steel fabricated by material extrusion additive manufacturing: Effect of relative density on physical, microstructural and mechanical behaviour
Parsompech, N., Suwanpreecha, C., Noraphaiphipaksa, N., Hararak, B., Songkuea, S., Schuschnigg, S., Kukla, C., Kanchanomai, C. & Manonukul, A., 14 Sept 2024, In: Materials Science and Engineering: A. 915.2024, November, 14 p., 147270.Research output: Contribution to journal › Article › Research › peer-review
- Published
Influence of cavity pressure and injection rate on the surface roughness of PP, PC, ABS and ABS-PC
Pacher, G., Berger, G. & Friesenbichler, W., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Influence of cavity pressure and injection rate on the surface roughness of PP, PC, ABS and ABS-PC
Pacher, G., Berger, G. & Friesenbichler, W., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
On the evaluation of the visual impact of sink marks of injection molded parts
Pacher, G. A., 2009Research output: Thesis › Master's Thesis
- Published
Abrasive wear measurements of various polyamide compounds under real-injection molding conditions
Oláh, L. & Friesenbichler, W., 2009,PPS 2009 Programme & Abstracts
. p. 56-56Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Wear of plastic mold steels under injection molding conditions
Oláh, L. & Friesenbichler, W., 2009, In: Transactions of FAMENA. 33, p. 15-24Research output: Contribution to journal › Article › Research › peer-review
- Published
Processability and mechanical properties of extensively recycled high density polyethylene
Oblak, P., Gonzalez-Gutierrez, J., Zupančič, B., Aulova, A. & Emri, I., 1 Jan 2015, In: Polymer Degradation and Stability. 114, p. 133-145 13 p.Research output: Contribution to journal › Article › Research › peer-review
