Chair of Polymer Processing (350)
Organisational unit: Chair
21 - 30 out of 946Page size: 10
Research output
- 2005
- Published
Investigation of Flow Behaviour of Extrudable Wood/Melamine Resin Composites
Nguyen, H. L., Duretek, I., Müller, U., Friesenbichler, W. & Endesfelder, A., 2005, Proceedings of the 2nd Annual European Rheology Conference. p. ---Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Measurement of polymer melts’ viscosity at increased pressure levels with the consideration of the compression heat
Rajganesh Jegadeesan, X., 2005, 98 p.Research output: Thesis › Master's Thesis
- Published
Moderne Berechnungsmethoden zur Auslegung von Schnecken und Extrusionswerkzeugen
Langecker, G. & Fertschej, A., 2005, In: Österreichische Kunststoff-Zeitschrift. p. 192-195Research output: Contribution to journal › Article › Research › peer-review
- Published
Polymer Melt Rheology at High shear rates Using a New Micro-Rheology Technique,
Friesenbichler, W., Langecker, G., Duretek, I. & Schuschnigg, S., 2005, Proceeding of the 21st Annual Meeting of the Polymer Processing Society. p. 87--Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Schwindung und Verzug folienhinterspritzter Formteile
Fertschej, A. & Langecker, G., 2005, In: Kunststoffe - Plast Europe. 95, p. 43-45Research output: Contribution to journal › Article › Research › peer-review
- Published
Simulation des Aufheizvorganges beim Thermoformen mittels der Methode der Finiten Differenzen
Kertz, J., Fertschej, A. & Langecker, G., 2005, In: VLK-News. 13, p. 4-7Research output: Contribution to journal › Article › Research › peer-review
- Published
Untersuchung der Abformgüte unterschiedlicher Oberflächenstrukturen beim Spritzgießen von PP und PC unter Variation der Prozessparameter
Hödl, H. M., 2005, 131 p.Research output: Thesis › Diploma Thesis
- 2006
- Published
19. Leobener Kunststoff Kolloquium - Spritzgieß- und Extrusionstechnik - Innovationen aus Industrie und Forschung
Friesenbichler, W. (Editor) & Laske, S. (Editor), 2006, Eigenverlag.Research output: Book/Report › Book › Research
- Published
Abrasive/corresive Wear on Plastic Mould Steels, measured under practical conditions
Friesenbichler, W., Langecker, G. & Caliskanoglu, D., 2006, Tooling Materials and their applications from research to market. p. 267-290Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
A Desgin Support System for Plastic Injection Molds: 22nd Annual Meeting of the Polymer Processing Society, Conference Proceedings
Langecker, G., Lucyshyn, T. & Fischer, K., 2006Research output: Non-textual form › Web publication/site › Research
