Chair of Polymer Processing (350)
Organisational unit: Chair
881 - 890 out of 946Page size: 10
Research output
- Published
Design of a Demolding Force Measurement Tool for Injection Molding
Struklec, T., Burgsteiner, M., Lucyshyn, T., Balika, W., Moderegger, S. & Holzer, C., 2013, Proceedings of the Polymer Processing Society 29th Annual Meeting ~ PPS-29. p. xxx-xxxResearch output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
On the demolding of micro-structured surfaces for medical applications
Struklec, T., 2011, 78 p.Research output: Thesis › Master's Thesis
- Published
Demolding of micro-structured surfaces in the injection molding process
Struklec, T., 2015Research output: Thesis › Doctoral Thesis
- Published
Herstellung medienführender Leitungen durch Kombination von Coinjektion und Wasserinjektionstechnik
Stückler, S., 2011Research output: Thesis › Master's Thesis
- Published
In-situ alignment of 3D printed anisotropic hard magnets
Suppan, M., Huber, C., Mathauer, K., Abert, C., Bruckner, F., Gonzalez-Gutierrez, J., Schuschnigg, S., Groenefeld, M., Teliban, I., Kobe, S., Saje, B. & Suess, D., 20 Oct 2022, In: Scientific reports (London : Nature Publishing Group). 12.2022, October, 6 p., 17590.Research output: Contribution to journal › Article › Research › peer-review
- Published
Effect of LOHC on HDPE and POK under different temperature conditions
Surisetty, J. S. S., Lucyshyn, T. (Editor) & Holzer, C., 7 Sept 2023.Research output: Contribution to conference › Poster › Research
- Published
Investigating the Aging Behavior of High-Density Polyethylene and Polyketone in a Liquid Organic Hydrogen Carrier
Surisetty, J. S. S., Sharifian, M., Lucyshyn, T. & Holzer, C., 15 Nov 2023, In: Polymers. 15.2023, 22, 14 p., 4410.Research output: Contribution to journal › Article › Research › peer-review
- Published
Neuentwicklung eines Tauchcomputers mit berührungssensitivem Display
Thallinger, F., 2015Research output: Thesis › Master's Thesis
- Published
Berechnungsmodell für Maddock- und Wendelscherteile in der Einschneckenplastifiziertechnologie
Thiel, H., 2007, 97 p.Research output: Thesis › Diploma Thesis
- Published
Fused filament fabrication, debinding and sintering as a low cost additive manufacturing method of 316L stainless steel
Thompson, Y., Gonzalez-Gutierrez, J., Kukla, C. & Felfer, P., 9 Sept 2019, In: Additive Manufacturing. 30.2019, December, 8 p., 100861.Research output: Contribution to journal › Article › Research › peer-review
