Chair of Mechanical Engineering (140)
Organisational unit: Chair
Research output
- Published
Comparison of Fatigue Behavior of Different Materials under Rolling Contact Fatigue
Magritzer, M., Wohlfahrt, M., Guster, C., Godor, I. & Grün, F., 2012.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Comparison of gear tooth root stresses by analytical, numerical and experimental evaluation
Leitner, M., Haberer, C. & Eichlseder, W., 2009, 26th Danubia-Adria Symposium on Advances in Experimental Mechanics. p. 269-270Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Comparison of gear tooth root stresses by analytical, numerical and experimental evaluation
Leitner, M., Haberer, C. & Eichlseder, W., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Comparison of microstructural crack paths between hypo-eutectic Al-Si-Cu and Al-Si-Mg cast alloys in high plasticity regimes under rotating bending
Huter, P., Winter, G., Renhart, P., Schwab, M., Oberfrank, S., Grün, F. & Stauder, B., 2014, In: Materials science and engineering: A, Structural materials: properties, microstructure and processing. 618, p. 578-585Research output: Contribution to journal › Article › Research › peer-review
- Published
Comparison of the Teperature and Pre-Aging Influences on the Low Cycle Fatigue and Thermo-Mechanical Fatigue Behaviour of Copper Alloys (CuCoBe/CuCo2Be)
Köberl, H., Winter, G., Leitner, H. & Eichlseder, W., 2008, In: Journal of ASTM international. Vol.5, p. 1-12Research output: Contribution to journal › Article › Research › peer-review
- Published
Compound Material Friction Temperature Dependency-Development of Finite Element Model
Vitek, T., Grün, F. & Leitgeb, A., 2006.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Comprehensive Study of ZDDP-tribofilms Formed under Soft Contact Conditions
Pondicherry, K., Grün, F., Summer, F., Godor, I., Lainé, E. & Offenbecher, M., 2013, Proceedings of 5th World Tribology Congress (WTC). p. 1-3Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Computational Fatigue Optimization – Application for purposeaimed Component and Forging Process Design
Riedler, M., Stockinger, M., Stoschka, M., Oberwinkler, B. & Tan, W., 2009, Eucomas2009. p. 20-21Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Computation of a modified Haigh-Goodman diagram for damage tolerant design for infinite fatigue life
Gänser, H.-P., 2007, In: Proceedings of the Institution of Mechanical Engineers / C (Part C, Journal of mechanical engineering science). 221, p. 619-623Research output: Contribution to journal › Article › Research › peer-review
- Published
Computed Tomography- an Alternative and Complement to Traditional Metallographic Investigations of Porosity in Cast Aluminium
Powazka, D., Brune, M., Eichlseder, W., Leitner, H. & Oppermann, H., 2008, Computed Tomography- an Alternative and Complement to Traditional Metallographic Investigations of Porosity in Cast Aluminium. p. 51-66Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
