Journal of ASTM international

Journal

1 - 9 out of 9Page size: 10

Research output

  1. 2010
  2. Published

    Importance of Residual Stresses and Surface Roughness Regarding Fatigue of Titanium Forgings

    Oberwinkler, B., Riedler, M. & Eichlseder, W., 2010, In: Journal of ASTM international. 7

    Research output: Contribution to journal › Article › Research › peer-review

  3. Published

    Liftime Calculation of thermo-Mechanically Loaded Materials (Al, Cu, Ni, and Fe Alloys) Based un Empirical Methods

    Köberl, H., Winter, G. & Eichlseder, W., 2010, In: Journal of ASTM international. Vol. 8, p. 1-11

    Research output: Contribution to journal › Article › Research › peer-review

  4. 2009
  5. Published

    A Novel Approach to Model Moving Heat Sources

    Fischer, F. D., Krempaszky, C., Ocenasek, J. & Werner, E., 2009, In: Journal of ASTM international. 6, p. 1-6

    Research output: Contribution to journal › Article › Research › peer-review

  6. Published

    The Definition of the Influence of Pore Size on the Fatigue Limit Using Short Crack Growth Experiments

    Oberwinkler, C., Eichlseder, W. & Leitner, H., 2009, In: Journal of ASTM international. p. 54-68

    Research output: Contribution to journal › Article › Research › peer-review

  7. 2008
  8. Published

    Comparison of the Teperature and Pre-Aging Influences on the Low Cycle Fatigue and Thermo-Mechanical Fatigue Behaviour of Copper Alloys (CuCoBe/CuCo2Be)

    Köberl, H., Winter, G., Leitner, H. & Eichlseder, W., 2008, In: Journal of ASTM international. Vol.5, p. 1-12

    Research output: Contribution to journal › Article › Research › peer-review

  9. Published

    Influence of the Peening Intensity on the Fatigue Behavior of Shot Peened Titanium Components

    Leitner, H., Oberwinkler, B., Gänser, H-P. & Stoschka, M., 2008, In: Journal of ASTM international. 5, p. 1-10

    Research output: Contribution to journal › Article › Research › peer-review

  10. 2006
  11. Published

    Characterization of Wear and Surface Reaction Layer Formation on Aerospace Bearing Steel M50 and a Nitrogen-alloyed Stainless Steel

    Peißl, S. K., Leitner, H., Ebner, R., Hutter, H., Krecar, D. & Rabitsch, R., 2006, In: Journal of ASTM international. 3, p. 1-10

    Research output: Contribution to journal › Article › Research › peer-review

  12. 2005
  13. Published

    Effect of residual stresses on the fatigue crack propagation in welded joints

    Gubeljak, N., Predan, J., Pippan, R. & Oblak, M., 2005, In: Journal of ASTM international. 2, p. 1-18

    Research output: Contribution to journal › Article › Research › peer-review

  14. Published

    Periodic overloads in the near threshold regime

    Tabernig, B., Pippan, R., Foulquier, J., Rapaport, A. & Sereni, S., 2005, In: Journal of ASTM international. 1, p. 1-10

    Research output: Contribution to journal › Article › Research › peer-review

View graph of relations