Chair of Automation and Measurement (530)
Organisational unit: Chair
Research output
- Published
Instrumentation and Measurement Method for the Inspection of peeled Steel Rods
Reindl, I. & O'Leary, P., 2007.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Vermessung von geschälten Rundproben für Saarstahl AG
Reindl, I. & O'Leary, P., 2006Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
Lichtschnittverfahren
Reindl, I., 2004.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Proben von April 2005
Reindl, I. & O'Leary, P., 2005Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
Risserkennung auf Brammen
Reindl, I. & O'Leary, P., 2005Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
Optical Configurations, Methods and Algorithms for the Automatic Inspection on Metallic Surfaces
Reindl, I. M., 2006, 191 p.Research output: Thesis › Doctoral Thesis
- Published
Impact Characteristics and Repair Approaches of Distinct Bio-Based Matrix Composites: A Comparative Analysis
Ravindran, B., Agathocleous, T., Oswald-Tranta, B., Fauster, E. & Feuchter, M., 29 Mar 2024, In: Journal of composites science. 8.2024, 4, 20 p., 126.Research output: Contribution to journal › Article › Research › peer-review
- Published
Hardware in the Loop Simulation
Rath, G. & Probst, G., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Non-Linear Modelling and HIL Simulation of Hydraulic Cylinders for Hydro Turbine Governing System
Rath, G., O'Leary, P., Zaev, E., Tuneski, A. & Babunski, D., 2010, International Symposium Engergetics 2010. p. 379-391Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Study of the Horizontal Cutting Boom Motion with Electronic Control
Rath, G., 2007Research output: Book/Report › Commissioned report › Transfer › peer-review
