Fused filament fabrication (FFF) is a very popular additive manufacturing technique for the production of geometrically complex polymeric parts. FFF can also be used for the production of sintered magnetic parts, as part of the shaping, debinding and sintering (SDS) process. In order for sintering to be possible, it is recommended to prepare feedstock materials with 50 vol% or more filler content. However, when the filler content increases the properties required for FFF change. In this paper the mechanical properties of filaments, the viscosity of the molten feedstock, and surface properties of the solidified feedstock were investigated as a function of strontium ferrite powder content (53 to 60vol%). In addition printing trials were performed. It was observed that mechanical properties significantly decrease, the viscosity increases and the surface tension showed no changes as a function of powder loading. All materials were in principle printable, but the printing temperature had to be adjusted to print the most highly filled material due to its lower mechanical properties and higher viscosity.