Determining Metal Content in Waste Printed Circuit Boards and their Electronic Components

Publikationen: Beitrag in FachzeitschriftArtikelForschung(peer-reviewed)

Autoren

  • Aleksandra Anić-Vučinić
  • Gordan Bedeković
  • Renato Sarc
  • Vitomir Premur

Externe Organisationseinheiten

  • University of Zagreb, Faculty of Geotechnical Engineering
  • Universität Zagreb

Abstract

A wide range of published scientific articles on metal content in printed circuit boards show that it is necessary to determine the content of individual metals. The aim of this paper is to show how metal content varies according to the type and age of waste electrical and electronic equipment collected in the Republic of Croatia. Samples of cell phones, TV sets, and computers are collected. The metal content is determined for electronic components and printed circuit board base plates separately for different grain sizes (1-4 mm, 0.5-1 mm, 0.1-0.5 mm and < 0.1 mm). The results show that electronic components form a larger part of printed circuit board mass fraction depending on the equipment age and type. Generally, electronic components do have a higher mass fraction for most metals (like: aluminium, copper, nickel, zinc, gold, and silver in most cases) in comparison to printed circuit board base plates, but for certain metals (like: lead, tin) the opposite applies. The electronic components of larger grain sizes (1-4 mm and 0.5-1 mm) contain more aluminium, copper, and zinc, and less lead, while the smaller grain size fractions are richer in gold. The bare boards base plates of larger grain sizes contain more copper, lead and tin, while the smallest grain size class (< 0.1 mm) contains more aluminium and gold. No clear trends are noticed in the case of silver and lead.

Details

OriginalspracheEnglisch
Seiten (von - bis)590-602
Seitenumfang13
Fachzeitschrift Journal of sustainable development of energy, water and environment systems
Jahrgang8.2020
Ausgabenummer3
DOIs
StatusVeröffentlicht - Sept. 2020