Materials science and engineering: A, Structural materials: properties, microstructure and processing, 0921-5093
Fachzeitschrift: Zeitschrift
| ISSNs | 0921-5093 |
|---|---|
| Weitere suchbare ISSN (eISSN) | 1873-4936 |
91 - 100 von 178Seitengröße: 10
Publikationen
- 2014
- Veröffentlicht
Yield strength prediction in Ni-base alloy 718Plus based on thermo-kinetic precipitation simulation
Ahmadi, M. R., Povoden-Karadeniz, E., Whitmore, L., Stockinger, M., Falahati, A. & Kozeschnik, E., 1 Juli 2014, in: Materials Science and Engineering A. 608, S. 114-122 9 S.Publikationen: Beitrag in Fachzeitschrift › Artikel › Forschung › (peer-reviewed)
- Veröffentlicht
Comparison of microstructural crack paths between hypo-eutectic Al-Si-Cu and Al-Si-Mg cast alloys in high plasticity regimes under rotating bending
Huter, P., Winter, G., Renhart, P., Schwab, M., Oberfrank, S., Grün, F. & Stauder, B., 2014, in: Materials science and engineering: A, Structural materials: properties, microstructure and processing. 618, S. 578-585Publikationen: Beitrag in Fachzeitschrift › Artikel › Forschung › (peer-reviewed)
- Veröffentlicht
Hot-working behavior of an advanced intermetallic multi-phase gamma-TiAl based alloy
Schwaighofer, E., Clemens, H., Lindemann, J., Stark, A. & Mayer, S., 2014, in: Materials science and engineering: A, Structural materials: properties, microstructure and processing. 614, S. 297-310Publikationen: Beitrag in Fachzeitschrift › Artikel › Forschung › (peer-reviewed)
- Veröffentlicht
Microstructural investigation of thermally aged nickel-based superalloy 718Plus
Whitmore, L., Ahmadi, M. R., Stockinger, M., Povoden-Karadeniz, E., Kozeschnik, E. & Leitner, H., 2014, in: Materials science and engineering: A, Structural materials: properties, microstructure and processing. 594, S. 253-259Publikationen: Beitrag in Fachzeitschrift › Artikel › Forschung › (peer-reviewed)
- Veröffentlicht
The microstructure of heat-treated nickel-based superalloy 718Plus
Whitmore, L., Ahmadi, M. R., Guetaz, L., Leitner, H., Povoden-Karadeniz, E., Stockinger, M. & Kozeschnik, E., 2014, in: Materials science and engineering: A, Structural materials: properties, microstructure and processing. 610, S. 39-45Publikationen: Beitrag in Fachzeitschrift › Artikel › Forschung › (peer-reviewed)
- 2013
- Veröffentlicht
The influence of microstructure and operating temperature on the fatigue endurance of hot forged Inconel (R) 718 components
Maderbacher, H., Oberwinkler, B., Gänser, H-P., Tan, W., Rollett, M. & Stoschka, M., 15 Nov. 2013, in: Materials science and engineering: A, Structural materials: properties, microstructure and processing. 585, S. 123-131Publikationen: Beitrag in Fachzeitschrift › Artikel › Forschung › (peer-reviewed)
- Veröffentlicht
Activation Parameters for Deformation of Ultrafine-Grained Aluminium as Determined by Indentation Strain Rate Jumps at Elevated Temperature
Wheeler, J. M., Maier, V., Durst, K., Göken, M. & Michler, J., 2013, in: Materials science and engineering: A, Structural materials: properties, microstructure and processing. 585, S. 108-113Publikationen: Beitrag in Fachzeitschrift › Artikel › Forschung › (peer-reviewed)
- Veröffentlicht
Direct or indirect: Influence of type of retained austenite decomposition during tempering on the toughness of a hot-work tool steel
Lerchbacher, C., Zinner, S. & Leitner, H., 2013, in: Materials science and engineering: A, Structural materials: properties, microstructure and processing. 564, S. 163-168Publikationen: Beitrag in Fachzeitschrift › Artikel › Forschung › (peer-reviewed)
- Veröffentlicht
Influence of bulk pre-straining on the size effect in nickel compression pillars
Schneider, A. S., Kiener, D., Yakacki, C. M., Maier, H. J., Gruber, P. A., Tamura, N., Kunz, M., Minor, A. M. & Frick, C. P., 2013, in: Materials science and engineering: A, Structural materials: properties, microstructure and processing. 559, S. 147-158 12 S.Publikationen: Beitrag in Fachzeitschrift › Artikel › Forschung › (peer-reviewed)
- Veröffentlicht
Influence of grain shape and orientation on the mechanical properties of high pressure deformed nickel
Rathmayr, G. B., Hohenwarter, A. & Pippan, R., 2013, in: Materials science and engineering: A, Structural materials: properties, microstructure and processing. 560, S. 224-231Publikationen: Beitrag in Fachzeitschrift › Artikel › Forschung › (peer-reviewed)
