TY - JOUR

T1 - Microstructure, Plasticity and Ductility of a TNM+ Alloy Densified by Spark Plasma Sintering

AU - Musi, Michael

AU - Deshayes, Christophe

AU - Molénat, Guy

AU - Toualbi, Louise

AU - Galy, Benjamin

AU - Spörk-Erdely, Petra

AU - Hantcherli, Muriel

AU - Monchoux, Jean-Philippe

AU - Thomas, Marc

AU - Clemens, Helmut

AU - Couret, Alain

PY - 2022/11/8

Y1 - 2022/11/8

N2 - This work presents a study of the microstructure and mechanical properties of a TNM+ alloy (Ti-43.5Al-4Nb-1Mo-0.1B-0.3C-0.3Si, in at.%) densified by Spark Plasma Sintering (SPS), in comparison to the as-SPSed TNM alloy, which contains neither carbon nor silicon. Tensile tests at room temperature and 800 °C, as well as creep tests at 800 °C and 200 MPa, were performed. The microstructures and the fracture surfaces of deformed samples were studied by scanning and transmission electron microscopies, as well as by X-ray diffraction. The deformation mechanisms were investigated by means of in situ straining experiments and post-mortem analyses of deformed samples, both performed by transmission electron microscopy. Contrary to the TNM alloy, the as-SPSed microstructure of the TNM+ alloy does not contain β/βo phase due to the incorporation of carbon. At room temperature, the TNM+ alloy exhibits a yield stress of 520 MPa but a poor ductility of less than 0.1% of plastic strain. The incorporation of carbon and silicon leads to an increase in the creep resistance of the alloy at 800 °C. Despite the fact that iron inclusions are responsible for the premature failure of some samples during tensile tests, the TNM+ alloy is found to be able to deform plastically at room temperature by the glide of ordinary dislocations and by twinning.

AB - This work presents a study of the microstructure and mechanical properties of a TNM+ alloy (Ti-43.5Al-4Nb-1Mo-0.1B-0.3C-0.3Si, in at.%) densified by Spark Plasma Sintering (SPS), in comparison to the as-SPSed TNM alloy, which contains neither carbon nor silicon. Tensile tests at room temperature and 800 °C, as well as creep tests at 800 °C and 200 MPa, were performed. The microstructures and the fracture surfaces of deformed samples were studied by scanning and transmission electron microscopies, as well as by X-ray diffraction. The deformation mechanisms were investigated by means of in situ straining experiments and post-mortem analyses of deformed samples, both performed by transmission electron microscopy. Contrary to the TNM alloy, the as-SPSed microstructure of the TNM+ alloy does not contain β/βo phase due to the incorporation of carbon. At room temperature, the TNM+ alloy exhibits a yield stress of 520 MPa but a poor ductility of less than 0.1% of plastic strain. The incorporation of carbon and silicon leads to an increase in the creep resistance of the alloy at 800 °C. Despite the fact that iron inclusions are responsible for the premature failure of some samples during tensile tests, the TNM+ alloy is found to be able to deform plastically at room temperature by the glide of ordinary dislocations and by twinning.

U2 - 10.3390/met12111915

DO - 10.3390/met12111915

M3 - Article

VL - 12.2022

JO - Metals : open access journal

JF - Metals : open access journal

SN - 2075-4701

IS - 11

M1 - 1915

ER -