Patrik Huter
(Former)
1 - 10 out of 26Page size: 10
Research output
- Published
1st Preliminary Report - Sehitoglu Material Characterisation of cast iron and cupper based alloys
Huter, P. & Winter, G., 2012Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
Automated Parameter Finding Procedure for Material Parameters of TMF-Hysteresis
Huter, P., 2012, 3rd Fatigue Symposium Conference Transcript. p. 255-265Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Comparative damage analysis of two cylinder heads
Huter, P., 2013Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
Comparison and Evaluation of Damage Indicated Thermo-Mechanical Fatigue Life Prediction for Cylinder Head Application
Huter, P., 2013, Seventh International Conference on Low Cycle Fatigue. p. 565-572Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Comparison of microstructural crack paths between hypo-eutectic Al-Si-Cu and Al-Si-Mg cast alloys in high plasticity regimes under rotating bending
Huter, P., Winter, G., Renhart, P., Schwab, M., Oberfrank, S., Grün, F. & Stauder, B., 2014, In: Materials science and engineering: A, Structural materials: properties, microstructure and processing. 618, p. 578-585Research output: Contribution to journal › Article › Research › peer-review
- Published
Damage prediction for un-coated and coated aluminum alloys under thermal and mechanical fatigue loadings based on a modified plastic strain energy approach: Lightweight Materials and Structural Solutions for Transport Applications
Azadi, M., Farrahi, G. H., Winter, G., Huter, P. & Eichlseder, W., 5 Feb 2015, In: Materials and Design. 66, 5, p. 587 595 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Einfluss von Legierung und Wärmebehandlung auf thermomechanische Eigenschaften von Zylinderköpfen
Stauder, B., Stika, P., Rafetzeder, M. & Huter, P., 2013, Energieeffizienz bei der Herstellung und dem Einsatz von Gussteilen. p. x-xResearch output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Endbericht FFG2116580 TMF-Alu
Huter, P., 2014Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
Entwicklung einer Umlaufbiege-Prüfmaschine für die In-situ Untersuchung der Rissinitiierung und des mikrostrukturellen Rissfortschritts
Huter, P., 2011Research output: Thesis › Diploma Thesis
- Published
Final report-HCF and TMF tests on specimens of an aluminium cast material
Huter, P., 14 Aug 2015Research output: Book/Report › Commissioned report › Research
