Bernd Haar
(Former)
1 - 5 out of 5Page size: 10
Research output
- 2024
- Published
Feasibility study on the production of low melt flow rate recycled polypropylene from postconsumer waste
Geier, J., Barretta, C., Hinczica, J., Haar, B., Bredács, M., Witschnigg, A., Mayrbäurl, E. & Oreski, G., 10 Aug 2024, In: Journal of applied polymer science. 141, 30, e55694.Research output: Contribution to journal › Article › Research › peer-review
- 2017
- E-pub ahead of print
The effects of e-beam crosslinking of LDPE on the permeation of hydrocarbons
Berger, K., Keimel, C., Helfer, E., Haar, B., Mattausch, H., Riess, G. & Kern, W., 6 Mar 2017, (E-pub ahead of print) In: Journal of Applied Polymer Science. 134.2017, 25, 8 p., 44968.Research output: Contribution to journal › Article › Research › peer-review
- 2016
- Published
Einfluss des relativen Druckwinkels auf die Oberflächentopologie von mittels FFF-Technik 3D-gedruckten Bauteilen
Haar, B., Walluch, M., Anna, U., Katschnig, M. & Holzer, C., 14 Apr 2016, p. 191-192. 2 p.Research output: Contribution to conference › Poster › Research
- Published
iPrint - Personalisierte Kranialimplantate mittels Fused Filament Fabrication
Katschnig, M., Haar, B., Holzer, C., Ücal, M., Schäfer, U., von Campe, G. & Zefferer, U., 14 Apr 2016, 25. Leobener Kunststoff-Kolloquium: Kunststoffgerechte Bauteilentwicklung - vom Werkstoff zum Produkt. Leoben, Vol. 06. p. 121-125 5 p. (Schriftenreihe Kunststofftechnik Leoben).Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- 2015
- Published
Influence of the relative printing angle on surface topography of 3d printed parts manufactured by fff technique
Haar, B., Walluch, M., Katschnig, M. & Holzer, C., 23 Sept 2015.Research output: Contribution to conference › Poster › Research › peer-review
