Departments and Chairs
Organisational unit: Departments and Institutes
31 - 40 out of 33,496Page size: 10
Research output
- Published
Analyse der Rissentwicklung in Zn-Al-Mg-Beschichtungen
Zunko, H., Hackl, A., Ebner, R., Brisberger, R., Priewasser, F., Riener, C. & Antrekowitsch, H., 2009, In: Berg- und hüttenmännische Monatshefte : BHM. 154, p. 334-341Research output: Contribution to journal › Article › Research › peer-review
- Published
Investigation on Cracking Behaviour of new Zn-based Coatings on Sheet Steel for Hot Dip Galvanising
Zunko, H., Hackl, A., Antrekowitsch, H., Ebner, R. & Brisberger, R., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Untersuchung des Mikrorissverhaltens von Zn-Al-Mg-Überzügen auf Stahlbändern
Zunko, H., 2010Research output: Thesis › Doctoral Thesis
- Published
Untersuchung der Einflussfaktoren bei der Herstellung von schäumfähigem Halbzeug über das Conformverfahren
Zunko, H., 2006Research output: Thesis › Diploma Thesis
- Published
Management of Critical Lower-Tier Suppliers in Global Networks: Practical Relevance, Literature Review and Management Perspectives
Zunk, B. M., Woschank, M., Reinisch, M. G. & Weller, S. B., 31 Dec 2020, In: IEEE engineering management review. 48, 4, p. 181-194Research output: Contribution to journal › Article › Research › peer-review
- Published
Engineering Excellence for the Mobility Value Chain
Zunk, B. M., Woschank, M., Pacher, C., Glinik, M., Vorbach, S., Koch, V. & Jantschgi, J., 1 Oct 2023, Proceedings of ICL2023 – 26th International Conference on Interactive Collaborative Learning. p. 1573-1584Research output: Chapter in Book/Report/Conference proceeding › Chapter › Research
- Published
Characterization and modeling of the cure-induced shrinkage of an epoxy resin used in organic laminate based electronic modules
Zündel, J. V., 2018Research output: Thesis › Master's Thesis
- Published
Determination of Antimony Saturation in Harris Slags
Zummar Ghazaleh, S. J., 2022Research output: Thesis › Master's Thesis
- Published
Flexible nanoporous activated carbon for adsorption of organics from industrial effluents
Zulfiqar, U., Kostoglou, N., Thomas, A. G., Rebholz, C., Matthews, A. & Lewis, D. J., 27 Aug 2021, In: Nanoscale. 13.2021, 36, p. 15311-15323 13 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Computational Analysis of the yield stress of ultra-high strength all-weld metals
Zügner, D., Holly, S., Ernst, W., Schnitzer, R. & Kozeschnik, E., 2018, 12th International Seminar on Numerical Analysis of Weldability.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
