Department Polymer Engineering and Science
Organisational unit: Departments and Institutes
Research output
- Published
Characterization of slow crack growth resistance of polyethylene pipe grades with cyclic cracked round bar (CRB) test in correlation to strain hardening (SH) test
Berger, I. J., Frank, A., Arbeiter, F. & Pinter, G., 8 May 2017.Research output: Contribution to conference › Paper › peer-review
- Published
Investigation of the Failure Behavior of Polyethylene Electrofusion Sockets
Berger, I. J., Frank, A., Pinter, G. G., Nitsche, D. & Petry, D., 2018, Proceedings Plastics Pipes XIX.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Comparison of real and simulated failure times based on the slow crack growth behavior
Berger, I. J., Frank, A., Pinter, G. G., Nitsche, D. & Petry, D., 2018, Proceedings ANTEC 2018. 6 p.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Einfluss der Faserarchitektur auf die mechanischen Eigenschaften und die Schadenstolerenz von Geflechtlaminaten
Berger, I., Pinter, G. & Wolfahrt, M., 2011, 20. Leobener Kunststoff-Kolloquium: Polymerer Leichtbau. p. 187-181Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Influence of mold surface temperature on polymer part warpage in rapid heat cycle molding
Berger, G. R., Pacher, G. A., Pichler, A., Friesenbichler, W. & Gruber, D. P., 2014, Proceedings of PPS 2013 - 29th International Conference of the Polymer Processing Society, Conference Papers. Vol. 1593. p. 189-194 6 p.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Topografiemessung einer ungetemperten und einer getemperten mit Kunststoff beschichteten Aluminiumfolie
Berger, G. R. & Lang, R., 2007Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
Oberflächenenergie-Bestimmung bei realen Prozesstemperaturen in der Kunststoffverarbeitung
Berger, G., 2012.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Overview of influences on demolding forces in injection molding
Berger, G. & Friesenbichler, W., 2010, 4th International PMI Conference - Conference Proceedings. p. 197-206Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Influence on Demolding in Injection Moulding
Berger, G. & Friesenbichler, W., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Charakterisierung von Spritzgieß-Formteiloberflächen
Berger, G., Friesenbichler, W. & Gruber, D. P., 2007, In: KC-aktuell (Informationen aus dem Kunstoff-Cluster). p. 2-3Research output: Contribution to journal › Article › Research › peer-review
