Department Polymer Engineering and Science
Organisational unit: Departments and Institutes
Research output
- Published
More Gloss, less weld lines
Berger, G., Steinbichler, G. & Roock, S., 2011, In: Kunststoffe <München> / Kunststoffe international. p. 26-29Research output: Contribution to journal › Article › Research › peer-review
- Published
3D-Oberflächenvermessung von strukturierten Aluminiumfolien
Berger, G. & Lang, R., 2007Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
Prediction of friction in injection molding by wetting parameters?
Berger, G., Friesenbichler, W., Steffel, C. & Pacher, G., 2014, 6th International PMI Conference Proceedings. p. 61-66Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Structure Replication in Injection Moulding
Berger, G. & Friesenbichler, W., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
More Gloss, Fewer Weld Lines With Variothermal Molding
Berger, G., Roock, S., Steinbichler, G., Gießauf, J., Gruber, D. P. & Friesenbichler, W., 2013, In: Plastics technology. 59, 3, p. 30, 60-35, 62Research output: Contribution to journal › Article › Research › peer-review
- Published
Replication of Stochastic and Geometric Micro Structures. Aspects of Visual Appearance
Berger, G., Gruber, D. P., Friesenbichler, W., Teichert, C. & Burgsteiner, M., 2011, In: International polymer processing. XXVI, p. 313-322Research output: Contribution to journal › Article › Research › peer-review
- Published
Influence on Demolding in Injection Moulding
Berger, G. & Friesenbichler, W., 2009.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Influence of Mold Surface Temperature on Polymer Part Warpage in Rapid Heat Cycle Molding
Berger, G., Pacher, G., Gruber, D. P., Pichler, A. & Friesenbichler, W., 2013, 29th International Conference of the Polymer Processing Society. p. 49-49Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Reibwerte und Entformungskräfte im konventionellen Spritzguss. Vorhersage durch Grenzflächenspannung?
Berger, G., Friesenbichler, W., Teichert, C., Langecker, G. & Lugger, M., 2013, 22. Leobener Kunststoff-Kolloquium: Oberlfächen und Grenzflächen in der Polymertechnologie. p. 75-89Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Application of D-optimal design of experiments on process optimization of an automotive part
Berger, G., Luger, H.-J., Friesenbichler, W., Beytollahi, I., Gierth, M. & Filz, P., 2013, THE PROCEEDINGS OF THE AUSTRIAN – SLOVENIAN POLYMER MEETING 2013. p. 106-108Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
