Department Polymer Engineering and Science
Organisational unit: Departments and Institutes
Research output
- Published
Analog triggered image acquisation for optical measurement under cyclic load conditions
Vezer, S., Steinberger, R. & Major, Z., 2007.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Development of an in plane biaxial test setup for monotonic and cyclic tests
Vezer, S. & Major, Z., 2008.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Analog triggered image acqusition method for optical measurement under cyclic load conditions
Vezer, S. T. & Major, Z., 2008, In: Materials engineering. 15, 1, p. 5-13Research output: Contribution to journal › Article › Research › peer-review
- Published
Characterisation of the fatigue behavior of rubber by combined Wöhler on isocyclic analysis
Vezer, S. & Major, Z., 2007.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Development of fretting fatigue test system
Vezer, S. & Major, Z., 2008.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Experimental and numerical characterization of the fretting fatigue behavior of elastomers
Vezer, S. T., 2011, 158 p.Research output: Thesis › Doctoral Thesis
- E-pub ahead of print
A review of parameters affecting success of lower-limb prosthetic socket and liners and implementation of 3D printing technologies
Varsavas, S. D., Riemelmoser, F., Arbeiter, F. & Faller, L. M., 22 Sept 2022, (E-pub ahead of print) In: Materials Today: Proceedings. 70.2022, p. 425-430 6 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Advancements in Intelligent Rock Bolt Measurement: A General Approach
Varelija, M., Vailhe, P. & Hartlieb, P., 15 Nov 2024, Conference proceedings.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Effect of extrusion and fused filament fabrication processing parameters of recycled poly(ethylene terephthalate) on the crystallinity and mechanical properties
Van de Voorde, B., Katalagarianakis, A., Huysman, S., Toncheva, A., Raquez, J. M., Duretek, I., Holzer, C., Cardon, L., Bernaerts, K. V., Van Hemelrijck, D., Pyl, L. & Van Vlierberghe, S., Feb 2022, In: Additive Manufacturing. 50.2022, February, 14 p., 102518.Research output: Contribution to journal › Article › Research › peer-review
- Published
Development of Material and Processing Parameters for AM
Ureña, J., Blasco, J. R., Jordá, O., Martínez, M., Portolés, L., Gonzalez-Gutierrez, J. & Schuschnigg, S., 2024, Springer Tracts in Additive Manufacturing. Springer Nature, p. 231-306 76 p. (Springer Tracts in Additive Manufacturing; vol. Part F3252).Research output: Chapter in Book/Report/Conference proceeding › Chapter › Research
