Department Polymer Engineering and Science
Organisational unit: Departments and Institutes
Research output
- Published
Thiol‐Ene versus Binary Thiol–Acrylate Chemistry: Material Properties and Network Characteristics of Photopolymers
Sahin, M., Ayalur Karunakaran, S., Manhart, J. C., Wolfahrt, M., Kern, W. & Schlögl, S., 2016, In: Advanced engineering materials. 2016, 19, 19.Research output: Contribution to journal › Article › Research › peer-review
- Published
Thiol-Yne Based Low-Cytotoxic Monomers: Towards Biocompatible and Tough Photopolymers for 3D Printing;
Grießer, T., 11 Sept 2016.Research output: Contribution to conference › Presentation › Research
- Published
Thiol-Yne Derived Photopolymers from Low-Cytotoxic 3D-Printing Resins
Hartmann, D., Oesterreicher, A., Edler, M., Moser, A., Pinter, G. & Grießer, T., 2016.Research output: Contribution to conference › Presentation › Research › peer-review
- Published
Thiol-yne Derived Resins for 3D Printing of Biocompatible Structures
Oesterreicher, A., 2016Research output: Thesis › Doctoral Thesis
- Published
Thiol-Yne Photo-Click Chemistry—Towards Biocompatible and Tough Photopolymers for 3D Printing
Hartmann, D. G., Oesterreicher, A. (Co-editor) & Grießer, T. (Co-editor), 26 Nov 2018.Research output: Contribution to conference › Poster › Research
- Published
Thoughts on accounting for the scatter seen in delamination growth
Jones, R., Mujtaba, A., Kinloch, A., Brunner, A. & Stelzer, S., 23 Feb 2015.Research output: Contribution to conference › Presentation › Research
- Published
Thoughts on the scatter seen in cyclic Mode I fatigue delamination growth in DCB tests
Mujtaba, A., Stelzer, S., Brunner, A. J. & Jones, R., 2017, In: Composite structures. 160.2017, 15 January, p. 1329-1338 10 p.Research output: Contribution to journal › Article › Research › peer-review
- Published
Three-dimensional mechanical metamaterial with tunable engineering constants in a broad range
Fleisch, M., Pinter, G., Schlögl, S. & Berer, M., 5 Sept 2024, In: Results in Engineering. 23.2024, September, 4 p., 102860.Research output: Contribution to journal › Article › Research › peer-review
- Published
Three dimensional modelling of flow in the pressure build-up zone of the new conical co-rotating twin screw extruder
Selvasankar, R. K. & Schuschnigg, S., 2010, Book of Abstracts. p. 25-25Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Through thickness characterization of crack growth and process zone development in cyclically loaded PE-HD
Balika, W., Pinter, G. & Lang, R., 2005.Research output: Contribution to conference › Poster › Research › peer-review
