Department Polymer Engineering and Science
Organisational unit: Departments and Institutes
Research output
- Published
INFLUENCE OF FLUID PROPERTIES ON TRANSVERSE FABRIC COMPRESSIBILITY DURING IN-SITU IMPREGNATION
Bender, M. & Fauster, E., 5 Jul 2024, Proceedings of the 21st European Conference on Composite Materials: Volume 3 - Material and Structural Behavior – Simulation & Testing. 1 ed. Nantes, Vol. 3. p. 1140 - 1147 8 p.Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Finite element study of mode I crack opening effects in compression-loaded cracked cylinders
Berer, M., Mitev, I. & Pinter, G. G., 2017.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Fatigue Fracture Properties and Morphology of Polyoxymethylene (POM) Plates Produced under Moderate Processing Conditions
Berer, M., Halb, M., Feuchter, M., Pacher, G. & Pinter, G., 4 Nov 2018, In: International journal of polymer science . 2018, 18 p., 7410925.Research output: Contribution to journal › Article › Research › peer-review
- Published
Cyclic loading of polyetheretherketone at high tensile stress levels
Berer, M., Major, Z., Pinter, G., Constantinescu, D. M. & Marsavina, L., 2014, Experimental Stress Analysis and Materials 14. Trans Tech Publications, p. 12-16 5 p. (Key Engineering Materials; vol. 601).Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Characterization of the global deformation behaviour of engineering plastics rolls
Berer, M. & Major, Z., 2010, In: International journal of mechanics and materials in design. p. 1-9Research output: Contribution to journal › Article › Research › peer-review
- Published
Characterisation and simulation of the time dependent deformation behaviour of polymer roller
Berer, M. & Major, Z., 2007.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Elevated Pitting Wear of injection molded PEEK rolls
Berer, M., Major, Z. & Pinter, G., 2013, In: Wear. 297, p. 1052-1063Research output: Contribution to journal › Article › Research › peer-review
- Published
Determination of crack growth kinetics in non-reinforced semi-crystalline thermoplastics using the linear elastic fracture mechanics (LEFM) approach
Berer, M. & Pinter, G., 2013, In: Polymer Testing. 32, p. 870-879Research output: Contribution to journal › Article › Research › peer-review
- Published
Fracture Mechanical Analysis of Two Commercial Polyoxymethylene Homopolymer Resins
Berer, M., Pinter, G. & Feuchter, M., 5 Oct 2014, In: Journal of Applied Polymer Science. 131, 19Research output: Contribution to journal › Article › Research › peer-review
- Published
Investigation of the dynamic mechanical behavior of Polyetheretherketone (PEEK) in the high stress tensile regime
Berer, M., Major, Z., Pinter, G., Constantinescu, D. M. & Marsavina, L., 2014, In: Mechanics of time-dependent materials. 18, p. 663-684Research output: Contribution to journal › Article › Research › peer-review
