Department Polymer Engineering and Science
Organisational unit: Departments and Institutes
4081 - 4090 out of 4,192Page size: 10
Research output
- Published
Wareneingangskontrolle von rezyklierten und Neuware-Polypropylenen mittels Folienextrusion
Wögerbauer, V., 2024Research output: Thesis › Master's Thesis
- Published
Temperierte Zugversuche zur Bestimmung mechanischer Kennwerte und des Erscheinungsbildes von Lackfilmen und bandbeschichteten Blechen
Wohlscheiber, F., 2007Research output: Thesis › Diploma Thesis
- Published
Improvement of the long-term stability of ultra-high molecular weight polyethylene (UHMW-PE) for endoprostheses by stabilisation with [alpha]-tocopherol
Wolf, C., 2005Research output: Thesis › Doctoral Thesis
- Published
Werkstoffcharakterisierung, Materialmodellierung und Simulaton von CFK-Geflechtlaminaten
Wolfahrt, M., Cichosz, J., Gager, J., Hinterhölzl, R., Pettermann, H. E., Frieß, S., Pinter, G. & Noisternig, J., 2011, 20. Leobener Kunststoff-Kolloquium: Polymerer Leichtbau. p. 101-111Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Thermoplastische Faserverbundwerkstoffe im Automobilbau - Einsatzmöglichkeiten am Beispiel von CULT
Wolfahrt, M., Kastanis, D. & Tscharnuter, D., 2011.Research output: Contribution to conference › Poster › Research › peer-review
- Published
Braided Fabrics: Development and evaluation of adequate test methodologies for generating design allowables
Wolfahrt, M., Pinter, G., Zaremba, S., Ladstätter, E. & Reden, von, T., 2009, ANTEC 2009 Society of Plastics Engineers' Annual Technical Conference. p. 1-7Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Bestimmung von ILSS-Werten nach DIN EN ISO 14130
Wolfahrt, M., Pinter, G. & Lang, R., 2007Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
Einfluss des Aushärtegrades auf wesentliche Werkstoffeigenschaften eines Epoxidharz - Matrixwerkstoffes
Wolfahrt, M., Pilz, G. & Lang, R., 2005, 15. Symposium: Verbundwerkstoffe und Werkstoffverbunde. p. 199-204Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
- Published
Influence of the cure time on the apparent interlaminar shear strength of the toughened resin transfer moulding system PRIFORM© at a cure temperature of 180 °C
Wolfahrt, M. & Pinter, G., 2009Research output: Book/Report › Commissioned report › Transfer › peer-review
- Published
Effect of preform architecture on the mechanical and fatigue behavior of braided compositess for generating design allowables
Wolfahrt, M., Pinter, G., Zaremba, S., Reden, von, T. & Ebel, C., 2009, Sampe Europe 30 th Intern. Jubilee Conference and Forum. p. 271-276Research output: Chapter in Book/Report/Conference proceeding › Conference contribution
