Department Physics, Mechanics and Electrical Engineering

Organisational unit: Departments and Institutes

41 - 50 out of 2,058Page size: 10

Research output

  1. Published

    Wind Power Rotor Blade Stress Minimisation by Active Damping through Generator Torque Control

    Wörndle, R., Weiß, H. & Karall, T., 2006, 12th International Power Electronics and Motion Control Conference. p. 1-5

    Research output: Chapter in Book/Report/Conference proceeding › Conference contribution

  2. Published

    The manipulation of thin film layer growth of quaterphenyl on Au(111)

    Winkler, A., Müllegger, S., Salzmann, I., Resel, R., Hlawacek, G. & Teichert, C., 2004, Symposium on Surface Science 2004. p. 163-164

    Research output: Chapter in Book/Report/Conference proceeding › Conference contribution

  3. Published

    Messsystem mit Schutzkomponenten zum durchgängigen Test von ReUse-Lithium-Ionen-Hochenergiemodulen

    Winkler, T., 2016

    Research output: Thesis › Master's Thesis

  4. Published

    Elektrolok mit 2000 kg Re-Use-Lithium- Ionen-Batterien – Realisierung, Erfahrungen, Weiterarbeit

    Winkler, T. & Weiß, H., 2018, p. 161-166. 6 p.

    Research output: Contribution to conference › Poster › Research

  5. E-pub ahead of print

    Multi-method characterization approach to facilitate a strategy to design mechanical and electrical properties of sintered copper

    Wijaya, A., Eichinger, B., Chamasemani, F. F., Sartory, B., Hammer, R., Maier-Kiener, V., Kiener, D., Mischitz, M. & Brunner, R., 28 Sept 2020, (E-pub ahead of print) In: Materials and Design. 2021, 197, 11 p., 109188.

    Research output: Contribution to journal › Article › Research › peer-review

  6. Published

    Plastification and Damage in Wheel-Rail Rolling Contact – Case Study on a Crossing

    Wiest, M., Daves, W., Fischer, F. D. & Ossberger, H., 2005, In: Proceedings in applied mathematics and mechanics. 5, p. 67-70

    Research output: Contribution to journal › Article › Research › peer-review

  7. Published

    Finite Element Analyse des Überrollens eines Herzstückes

    Wiest, M., Daves, W., Fischer, F. D. & Ossberger, H., 2005, In: ZEVrail. 129, p. 461-467

    Research output: Contribution to journal › Article › Research › peer-review

  8. Published

    Deformation of Damage of a Crossing Nose Due to Wheel Passages

    Wiest, M., Daves, W., Fischer, F. D. & Ossberger, H., 2006, 7th Int. Conf. Contact Mechanics and Wear of Rail/Wheel Systems (CM2006). p. 517-525

    Research output: Chapter in Book/Report/Conference proceeding › Conference contribution

  9. Published

    Modeling of Wheel-Rail/Crossing Interactions

    Wiest, M., 2006, 102 p.

    Research output: Thesis › Doctoral Thesis

  10. E-pub ahead of print

    Effect of reverted austenite on tensile and impact strength in a martensitic stainless steel: An in-situ X-ray diffraction study

    Wießner, M., Gamsjäger, E., van der Zwaag, S. & Angerer, P., 12 Nov 2016, (E-pub ahead of print) In: Materials science and engineering: A, Structural materials: properties, microstructure and processing. 682.2017, 13 January, p. 117-125 9 p.

    Research output: Contribution to journal › Article › Research › peer-review

Previous 1 2 3 4 5 6 7 8 ...206 Next
View graph of relations