Department Materials Science

Organisational unit: Departments and Institutes

301 - 320 out of 5,453Page size: 20

Research output

  1. 2023
  2. Published

    Influence of the aspect ratio of the micro-cantilever on the determined Young’s modulus using the Euler-Bernoulli equation

    Konstantiniuk, F., Krobath, M., Ecker, W., Czettl, C., Schalk, N. & Tkadletz, M., Jun 2023, In: Materials Today Communications. 35.2023, June, 9 p., 106225.

    Research output: Contribution to journal › Article › Research › peer-review

  3. Published

    In Situ Observations of the Microstructural Evolution during Heat Treatment of a PH 13-8 Mo Maraging Steel

    Rosenauer, A., Brandl, D., Ressel, G., Lukas, S., Gruber, C., Stockinger, M. & Schnitzer, R., Jun 2023, In: Advanced engineering materials. 25.2023, 12, 12 p., 2300410.

    Research output: Contribution to journal › Article › Research › peer-review

  4. Published

    Severe plastic deformation close to the melting point enables Mg-Fe nanocomposites with exceptional strength

    Roostaei, M., Uggowitzer, P., Pippan, R. & Renk, O., Jun 2023, In: Scripta materialia. 230.2023, June, 5 p., 115428.

    Research output: Contribution to journal › Article › Research › peer-review

  5. Published

    Synthesis and mechanical properties of co-deposited W nanoparticle and ZrCuAg metallic glass thin film composites

    Huszar, E., Sharma, A., Székely, L., Raghavan, R., Putz, B., Edwards, T. E. J., Spolenak, R., Michler, J. & Pethö, L., 31 May 2023, In: Thin solid films. 773, 139822.

    Research output: Contribution to journal › Article › Research › peer-review

  6. Published

    Scaling up the cold sintering process of ceramics

    Jabr, A., Jones, H. N., Argüelles, A. P., Trolier-McKinstry, S., Randall, C. A. & Bermejo Moratinos, R., 30 May 2023, In: Journal of the European Ceramic Society. 43, 12, p. 5319-5329 11 p.

    Research output: Contribution to journal › Article › Research › peer-review

  7. E-pub ahead of print

    Phase equilibria in the Ti-Al-W system between 800 and 1300 ◦C

    Distl, B., Rashkova, B. & Stein, F., 23 May 2023, (E-pub ahead of print) In: Materials Today Communications. 35.2023, June, 15 p., 106291.

    Research output: Contribution to journal › Article › Research › peer-review

  8. Published

    High-Throughput Micromechanical Testing Enabled by Optimized Direct Laser Writing

    Jelinek, A., Žák, S., Alfreider, M. & Kiener, D., 22 May 2023, In: Advanced engineering materials. 2023, 25, 10 p., 2200288.

    Research output: Contribution to journal › Article › Research › peer-review

  9. Published

    Impact of d‑states on transition metal impurity diffusion in TiN

    Nayak, G. K., Holec, D. & Zelený, M., 22 May 2023, In: Scientific reports (London : Nature Publishing Group). 2023, 13, 11 p., 8244.

    Research output: Contribution to journal › Article › Research › peer-review

  10. Published

    Delignification and Densification as a Route to Enable the Use of Wheat Straw for Structural Materials

    Neudecker, F., Jakob, M., Bodner, S., Keckes, J., Buerstmayr, H. & Gindl-Altmutter, W., 4 May 2023, In: ACS Sustainable Chemistry and Engineering. 11.2023, 19, p. 7596-7604 9 p.

    Research output: Contribution to journal › Article › Research › peer-review

  11. Published

    Feasibility study on electrically conductive joining of MoSi2 electrodes for spark plugs

    Gruber, M., Tilz, A., Harrer, W. S., Papšík, R., Fimml, W. & Engelmayer, M., 1 May 2023, In: International journal of applied ceramic technology. 2023, p. 3257-3266 10 p.

    Research output: Contribution to journal › Article › Research › peer-review

  12. Published

    Models of configurationally-complex alloys made simple

    Gehringer, D., Friák, M. & Holec, D., May 2023, In: Computer physics communications. 286.2023, May, 11 p., 108664.

    Research output: Contribution to journal › Article › Research › peer-review

  13. E-pub ahead of print

    Lower hardness than strength: The auxetic composite microstructure of limpet tooth

    Wurmshuber, M., Wilmers, J., Kim, J., Oh, S. H., Bargmann, S. & Kiener, D., 29 Apr 2023, (E-pub ahead of print) In: Acta biomaterialia. 2023, 166, p. 447-453 7 p.

    Research output: Contribution to journal › Article › Research › peer-review

  14. Published

    Effect of pulse-current-based protocols on the lithium dendrite formation and evolution in all-solid-state batteries

    Reisecker, V., Flatscher, F., Porz, L., Fincher, C., Todt, J., Hanghofer, I., Hennige, V., Linares-Moreau, M., Falcaro, P., Ganschow, S., Wenner, S., Chiang, Y. M., Keckes, J., Fleig, J. & Rettenwander, D., 27 Apr 2023, In: Nature Communications. 14.2023, 12 p., 2432.

    Research output: Contribution to journal › Article › Research › peer-review

  15. Published

    Local gradients of microstructure and residual stresses in Si device sidewalls separated by laser dicing

    Ziegelwanger, T., Meindlhumer, M., Todt, J., Reisinger, M., Matoy, K. & Keckes, J., 24 Apr 2023.

    Research output: Contribution to conference › Poster › Research

  16. Published

    Fine-grained aluminium crossover alloy for high-temperature sheet forming

    Samberger, S., Weißensteiner, I., Stemper, L., Kainz, C., Uggowitzer, P. & Pogatscher, S., 19 Apr 2023, In: Acta materialia. 253.2023, 1 July, 14 p., 118952.

    Research output: Contribution to journal › Article › Research › peer-review

  17. E-pub ahead of print

    On correlations between local chemistry, distortions and kinetics in high entropy nitrides: An ab initio study

    Nayak, G. K., Kretschmer, A., Mayrhofer, P. H. & Holec, D., 19 Apr 2023, (E-pub ahead of print) In: Acta materialia. 255.2023, 15 August, 9 p., 118951.

    Research output: Contribution to journal › Article › Research › peer-review

  18. Published

    Strengthening effect of NiAl and Ni3Ti precipitates in Co-free maraging steels

    Zeisl, S., Van Steenberge, N. & Schnitzer, R., 19 Apr 2023, In: Journal of materials science. 58.2023, April, p. 7149–7160 12 p.

    Research output: Contribution to journal › Article › Research › peer-review

  19. Published

    Glide and mixed climb dislocation velocity in γ-TiAl investigated by in-situ transmission electron microscopy

    Galy, B., Musi, M., Hantcherli, M., Molénat, G., Couret, A., Spörk-Erdely, P., Clemens, H. & Monchoux, J.-P., 15 Apr 2023, In: Scripta materialia. 228.2023, 15 April, 8 p., 115333.

    Research output: Contribution to journal › Article › Research › peer-review

  20. Published

    Topography of high-speed steel substrates sputter cleaned by an Ar/Ti cathodic arc plasma

    Kampichler, J., Razumovskiy, V. I., Klünsner, T., Kholtobina, A., Brandstetter, F., Nahif, F. & Mitterer, C., 15 Apr 2023, In: Surface & coatings technology. 458.2023, 15 April, 10 p., 129344.

    Research output: Contribution to journal › Article › Research › peer-review

  21. E-pub ahead of print

    Interstitial segregation has the potential to mitigate liquid metal embrittlement in iron

    Ahmadian, A., Scheiber, D., Zhou, X., Gault, B., Romaner, L., Kamachali, R. D., Ecker, W., Dehm, G. & Liebscher, C., 8 Apr 2023, (E-pub ahead of print) In: Advanced materials. 35.2023, 28, 11 p., 2211796.

    Research output: Contribution to journal › Article › Research › peer-review

Previous 1...12 13 14 15 16 17 18 19 ...273 Next
View graph of relations

Contact information

Roseggerstraße 12 / Max-Tendler-Straße 9/1.UG, 8700 Leoben